Jeep Grand Cherokee SRT 2009 Quick Reference Guide

2009
QUICK
REFERENCE
GUIDE
GRAND
CHEROKEE
vehicle features
LOOSE GAS CAP MESSAGE
• If a “CHECK GASCAP” message appears in the Electronic Vehicle Information Center (EVIC), tighten the gas cap until a “clicking”
sound is heard.
• If the message continues to appear for more than three days after
tightening the gas cap, see your dealer.
TIRE PRESSURE MONITORING SYSTEM (TPMS):
• A Tire Pressure Monitoring Light and a “low tire” message will display
in your instrument cluster along with an audible chime if one or more of
your vehicle’s four road tires are signicantly under-inated.
• Check the ination pressure of each tire and inate to the recommended
pressure for your vehicle. The tire pressures recommended for your
vehicle are found on the “Tire and Loading Information” label located on
the driver’s side door opening. The TPMS light should not be used as a tire pressure gauge when adjusting your tire pressure.
• It is recommended that you check the tire pressure in the morning when tires are cool; inate each tire to the recommended pressure for
your vehicle. The light will turn off after your vehicle’s tire pressures are
properly inated and the pressure has been recognized. The vehicle may
need to be driven for up to 20 minutes above 15 mph (25 km/h) before the light will turn off.
• T
emperature changes can affect tire pressure, causing the TPMS light to turn on. Tire pressures will also increase as the vehicle is driven - this is normal and you should not adjust for this increased pressure.
• Driving on under-inated tires reduces your vehicle’s fuel efciency and tire tread life. If a spare tire is in use on the vehicle, the TPMS light may
turn on. Refer to your Owner’s Manual.
OIL CHANGE INDICATOR:
MESSAGE
• A “CHAngE OIL” or “Oil Change Required” message will illuminate and a single chime will sound when it is time for your next required oil change.
RESETTING LIGHT AFTER SERVICING
• Turn the ignition switch to the ON/RUN position (do not start engine).
• Fully depress the accelerator pedal three times within 10 seconds.
• Turn the ignition switch to the OFF/LOCK position.
Rotate Temp. Control
Press A/C
Button
Press Rear W in dow
Defroster Button
Rotate Blower Control Rotate Mode Control
MANUAL CLIMATE CONTROLS:
AIR RECIRCULATION
• Use recirculation for MAX A/C operation.
• For window defogging, turn recirculation off.
• Recirculation is not allowed in defrost, oor, defrost/oor (mix) modes.
DRIVER MEMORY SEAT:
• T he memory seat feature allows you to save two different driver
seating positions. The memory seat switches are located on the driver’s door panel. With the key in the ON/RUN position, push , then push 1 or 2 within ve seconds.
• P ush 1 or 2 to recall the saved positions.
• K ey Fobs may be programmed to automatically recall position
1 or 2 when UNLOCK is pushed.
• R efer to your Owner’s Manual for further details.
Recirc.
AUTOMATIC TEMPERATURE CONTROLS (ATC):
AUTOMATIC OPERATION
• Turn the Mode Control to the AUTO position and the Blower Control to either LO AUTO or HIGH AUTO position.
• Select the desired temperature by rotating the Temperature Control.
• The system will maintain the set temperature automatically.
AIR CONDITIONING
• If the air conditioning button is pressed while in the AUTO mode, the indicator light may ash three times to indicate the air conditioning is
being controlled automatically.
AIR RECIRCULATION
• Use recirculation for MAX A/C operation.
• For window defogging, turn air recirculation off.
• If the recirculation button is pressed while in the AUTO mode, the indicator light may ash three times to indicate the cabin air is being
controlled automatically.
WIND BUFFETING:
• Wind buffeting can be described as a helicopter-type percussion sound. If buffeting occurs with the rear windows open, adjust the front and rear
windows together.
• If buffeting occurs with the sunroof open, adjust the sunroof opening, or adjust any window. This will minimize the buffeting.
Rot ate Blo we r
Control
Press A/C
Button
Press Air Recirc.
Button
Rotate Driver
Temp. Control
Rotate Passenger
Temp. Control
Press Rear Window
Defroster Button
Rotate Mode
Control
CLOCK SETTING:
(NON-TOUCH-SCREEN RADIOS)
• Press and hold the TIME button until the hours blink; turn the TUNE/SCROLL control knob to set the hours.
• Press the TUNE/SCROLL control knob until the minutes begin to blink; turn the TUNE/SCROLL control knob to set the minutes.
• Press the TUNE/SCROLL control knob to save the time change.
(TOUCH-SCREEN RADIOS)
• Turn the radio ON.
• Touch the screen where the time is displayed.
• Touch the screen where “User Clock” is displayed (Navigation Radio Only).
• To adjust the hours, touch either the hour forward button or the hour
backward button.
• To adjust the minutes, touch either the minute forward button or the minute backward button.
• To save the new time setting, touch the screen where the word “Save” is displayed.
uconnect™ phone:
• uconnect™ phone is a voice-activated, hands-free, in-vehicle,
communications system. uconnect™ phone allows you to dial a phone number with your cellular phone using voice commands.
• uconnect
phone requires a cellular phone equipped with the Bluetooth® Hands-Free Prole, Version 0.96 or higher. See the www.jeep.com/uconnect website for supported phones. Refer to your Owner’s Manual for further information.
ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) CONTROLS:
• The EVIC features a driver interactive display that is located in the
instrument cluster. Pressing the controls on the steering wheel allows the driver to select vehicle information and Personal Settings.
instrument panel
TURN SIGNAL/ LIGHTS LEVER
ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) CONTROLS
INSTRUMENT CLUSTER/ EVIC
SPEED CONTROL LEVER
AUDIO SYSTEM
(TOUCH-SCREEN RADIO SHOWN)
CLIMATE CONTROLS
LOWER SWITCH PANEL
WIPER/ WASHER LEVER
UPPER SWITCH PANEL
KEY FOB:
LOCKING AND UNLOCKING THE DOORS/LIFTGATE
• Press the LOCK button once to lock all doors and liftgate.
• Press the UNLOCK button once to unlock the driver’s door only and
twice to unlock all the doors and liftgate.
• All doors can be programmed to unlock on the rst press of the UNLOCK button.
• Refer to the Owner’s Manual for programming.
REMOTE START
• Press the REMOTE START button twice within ve seconds. Pressing
the REMOTE START button a third time shuts the engine off.
• To drive the vehicle, press the UNLOCK button, insert the key in the
ignition and turn to the ON/RUN position.
• With remote start, the engine will only run for 15 minutes (timeout) unless
the ignition key is placed in the ON/RUN position.
• The vehicle must be started with the key after two consecutive timeouts.
PANIC ALARM
• Press the button once to turn the panic alarm on.
• Wait approximately three seconds and press the button a second time to
turn the panic alarm off.
Lock
Unlock
Remote Start
Flipper Glass/
Liftgate Release
TURN SIGNAL/LIGHTS LEVER:
HEADLIGHTS/PARKING LIGHTS/AUTOMATIC HEADLIGHTS
• Rotate the end of the lever to the rst detent for parking lights, the second
detent for headlights and the third detent for AUTO.
• This system automatically turns the headlights on or off based on
ambient light levels.
SmartBeams
• Automatically controls the use of the headlight high beams.
INSTRUMENT PANEL DIMMER
• Rotate the dimmer control to the extreme bottom position to fully dim the
instrument panel lights and prevent the interior lights from illuminating when a door is opened.
• Rotate the center portion of the lever up to increase the brightness of the
instrument panel lights when the parking lights or headlights are on.
• Rotate the center portion upward to the next detent position to brighten
the odometer and radio when the parking lights or headlights are on.
• Rotate the center portion upward to the last detent to turn on the interior lighting.
HIGH BEAM OPERATION
• Push the lever forward to activate the high beams.
FOG LIGHTS
• Turn on the parking lights or low beam headlights and pull out the end of
the lever.
Lights
Fog Lights
Dimmer
Push Lever for
High Beams
vehicle features
SPEED CONTROL LEVER:
CRUISE ON/OFF
• Press the ON/OFF button to activate the Speed Control.
• CRUISE will appear on the instrument cluster to indicate the Speed
Control is on.
• Press the ON/OFF button a second time to turn the system off.
SET
• With Speed Control on, press down and release the lever to set a desired speed.
ACCEL/DECEL
• Press and hold the lever up to accelerate or down to decelerate the
vehicle; release the lever to save the new set speed.
• Once a speed is set, tapping the lever up or down will increase or
decrease the set speed approximately 1 mph (2 km/h).
CANCEL
• Pull the lever toward you, or apply the brakes to cancel the set speed and maintain the set speed memory.
• Press the ON/OFF button to turn the system off and erase the set speed memory.
RESUME
• To resume a previously selected speed in memory, press the lever up and release.
Press ON/OFF Button
WIPER/WASHER LEVER:
FRONT WIPERS
Intermittent, Low and High Operation
• Rotate the end of the lever to the rst detent position for one of ve
intermittent settings, the second detent for low wiper operation and the third detent for high wiper operation.
Mist
• Pull down on the lever and release when a single wipe is desired.
Washer Operation
• Pull the lever toward you and hold for as long as spray is desired.
Rain Sensing Wipers
• This feature senses moisture on the vehicle’s windshield and
automatically activates the wipers for the driver when the switch is in the intermittent position. Refer to your Owner’s Manual for operation.
REAR WIPER
Wiper Operation
• Rotate the center portion of the lever forward to the rst detent for rear
wiper operation.
Washer Operation
• Rotate the center portion of the lever past the rst detent to activate the
rear washer.
Front Washer
(pull toward
driver)
Front WipersRear Wiper/Washer
Mist (down)
www.JEEP.com
Grand Cherokee Second Printing Quick Reference Guide
81-316-0971
This guide has been prepared to help you get quickly acquainted with your new Jeep and to provide a convenient reference source for common questions. However, it is not a substitute for your Owner’s Manual.
For complete operational instructions, maintenance procedures and important safety messages, please consult your Owner’s Manual, Navigation Radio User Manual, Multimedia User Manual and other Warning Labels in your vehicle.
Not all features shown in this guide may apply to your vehicle. For additional information on accessories to help personalize your vehicle, visit mopar.com or your local Jeep dealer.
MOPAR ACCESSORIES:
The following highlights just some of the Authentic Jeep Accessories by Mopar that are available for your Jeep Grand Cherokee.
CHROME:
• Tubular Side Steps • Grille • Front Air Deector
• Tail Lamp Guards • Fuel Door
EXTERIOR:
• Running Boards • Wheels • Air Deectors
• Tubular Grille
Guard
• Rock Rails • Tubular Side Steps
• Spoiler • Splash Guards • Skid Plates
ELECTRONICS:
• Rear Seat Video • uconnect™ web
(WiFi)
• SIRIUS Satellite
Radio
• Heated Seats • Rear View Camera • iPod
®
Adapter
CARRIERS:
• Roof-Mount Carriers • Trailering
Accessories
To see the full line of accessories, stop by your Jeep dealer or visit
mopar.com.
Loading...