EON 10 G2 Sys Man 5/15/03 2:47 PM Page 2
EON 10 G2 Sys Man 5/15/03 2:47 PM Page 4
Welcome
Welcome to the family of discerning sound equipment users who have selected JBL Professional
products. Your EON System is a creation of JBL, the world leader in sound reinforcement. JBL
sound systems are used in some of the world’s most famous arenas, concert halls and clubs. In
fact, JBL speakers are the premier choice for today’s hottest touring acts and artists. You just can’t
make a more professional choice.
This User’s Guide contains important information that will help you get the most from your
JBL EON sound system so please take a moment to read it and be sure to keep it in a safe
place for future reference.
Congratulations and thanks from all of us at JBL Professional. You have invested in the best
portable performance system available.
PACKAGE CONTENTS
Your EON10 G2 System should include the following:
• 1 EON MusicMix 14 Mixer
• 1 PSU (Power Supply Unit for mixer)
• 2 EON10 G2 Speakers
• 1 EON10 G2 User’s Guide
• 1 EON10 G2 System User’s Guide
• 2 10’ (3mm) IEC Power Cables
• 2 M50S Microphones
• 4 25’ (7.6 Meter) XLR/M to XLR/F Cables
AGENCY APPROVALS AND CERTIFICATIONS
This EON G2 System complies with all International Safety Requirements for Mains Operated
Professional audio equipment under IEC65, and electromagnetic compatibility, radio interference,
emissions and immunity requirements.
BEFORE YOU BEGIN - IMPORTANT INFORMATION
The EON MusicMix 14 mixer must only be connected through the Power Supply Unit (PSU)
supplied. Use of any other PSU will void your warranty.
Like any electrical appliances, neither the EON MusicMix 14 or the EON10 G2 speakers should be
used in water or when wet.
The EON MusicMix 14 and the EON10 G2 speakers contain no user serviceable parts. Refer
servicing to an authorized JBL service agency.
4
EON 10 G2 Sys Man 5/15/03 2:47 PM Page 6
Output Section
MON
This 1/4” phone jack output will be used primarily to drive the stage monitor system. The MON
output may be used for balanced or unbalanced operation.
EFX2 / MON2
This 1/4” phone jack output may be used to drive a second stage monitor system or a second
effects processor depending on the setting of the EFX2 / MON2 switch. The EFX2 / MON2 output
may be used with balanced or unbalanced input devices.
EFX
This 1/4” phone jack output may be used to drive an effects processor. The EFX2 / MON2 output
may be used with balanced or unbalanced input devices.
L/R SUM
This 1/4” phone jack output delivers a combination of the MIX L & R signals. The output level is
controlled by the L/R SUM knob. This output may be used to drive a subwoofer or a remote
speaker system covering an overflow area. This output may be used with balanced or unbalanced
devices.
MIX INSER
T L & R
These 1/4” phone jacks function in the same way as the channel INS jacks and allow a signal
processor to be inserted into the main stereo mix.
CONTROL ROOM OUT L & R
These 1/4” phone jacks are used to connect a control room (or booth) monitor system. This output
will carry the same signal as the headphone out. The CONTROL ROOM OUT jacks may also be
used to connect a recorder to record a performance. Note that if these jacks are used for recording
you must disconnect the headphones from the PHONES connector. You will also not be able to use
the LISTEN system while recording.
MIX L & MIX R
These balanced XLR connectors are the main stereo outputs of the mixer.
T
APE / CD IN
These RCA jacks are provided for connection of a tape, mini-disc, or CD player. The signal from
these jacks is controlled by the MIX / TAPE CD switch and the TAPE / CD LEVEL control.
PHONES
This stereo phone jack is provided for connection of headphones. Connecting headphones to this
jack will mute the CONTROL ROOM OUT.
PSU
This 3-pin connector is provided for connection of the Power Supply Unit. Note the tab release on
the cable connector for the PSU. This tab must be depressed to disconnect the PSU from the
mixer.
20
EON 10 G2 Sys Man 5/15/03 2:47 PM Page 8