Jaytech RDO 1000, RDO 1800 Installation Instructions And User Manual

RDO 1000 Roller Door Opener

WARNING

Please read this manual carefully before installation and use. The installation of your
new door opener must be carried out by a technically qualified person. Attempting to

install or repair the door opener without suitable technical experience may result in

severe personal injury, death and / or property damage.

RDO 1800 Light Industrial Roller

Door Opener

Installation Instructions and User Guide

- 1 -

START BY READING THESE IMPORTANT
SAFETY INSTRUCTIONS

WARNING

• Failure to comply with the following instructions may

result in serious personal injury or property damage.

• Read and follow all instructions carefully.

• This This opener is designed and manufactured to meet

Australian Standards AS/NZS 60335.2.95:2012 and

AS/NZS 60335.1:2011 when installed correctly.

These safety alert symbols mean WARNING : A possible

risk to personal safety or property damage exists.

1.Keep garage door balanced. Do not let the garage door

opener compensate for a binding or sticking garage door.

Sticking, binding or unbalanced doors must be repaired

before installing this opener.

2.Do not wear rings, watches or loose clothing. while

installing or servicing a garage door opener. Wear gloves and

suitable protective clothing where appropriate.

- 2 -

3.Frequently examine the door installation, in particular,

springs and mountings for signs of wear, damage or

imbalance. Do not use if repair or adjustment is needed since

springs and hardware are under extreme tension and a fault

can cause serious personal injury.

4.To avoid serious personal injury from entanglement,

remove all ropes, chains and locks connected to the

garage door before installing the door opener.

5.Installation and wiring must be in compliance with your

local building and electrical codes.

6.The safety reverse system test is very important. Your

garage door MUST reverse on contact with a 40 mm obstacle

placed on the floor. Failure to properly adjust the opener may

result in serious personal injury from a closing garage door.

Repeat the test once a month and make any necessary

adjustments.

7.This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capability,

or lack of experience and knowledge, unless they have been

- 3 -

given supervision or instruction concerning use of the

appliance by a person responsible for their safety.

8.Automatic Drive - Keep away from the area of the door as

it may operate unexpectedly.

9.This opener should not be installed in a damp or wet

space exposed to weather.

10.The opener must not be used on a wicket door (door

within a door).

11.Photo Beams must be used for all installations where

the closing force as measured on the bottom of the door

is over 400 N (40 kg). Excessive force will interfere with the

proper operation of the safety reverse system or damage the

garage door.

12.After installation, ensure that the parts of the door do

not extend over public footpaths or roads.

13. Install the wireless wall control (or any additional wall

control) in a location where the garage door is visible, at a

height of at least 1.5 m and out of the reach of children.

- 4 -

Do not allow children to operate push button(s) or

transmitter(s). Serious personal injury from a closing garage

door may result from misuse of the opener.

14.Permanently fasten the Warning Labels in prominent

places, adjacent to wall controls and manual release

mechanisms as a reminder of safe operating procedures.

15.Activate opener only when the door is in full view, free

of obstructions and the opener is properly adjusted. No

one should enter or leave the garage while the door is in

motion.

16.Do not allow children to play near the door, or with

door controls.

17. If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons

in order to avoid hazard.

18.Disconnect electric power and battery to the garage

door opener before making repairs or removing covers.

- 5 -

KEEP THESE INSTRUCTIONS

CONTENTS

PAGE

CONTENTS

PAGE

SAFETY INSTRUCTIONS························· 1-5

IR Beam setting·················································12

PACKING LIST······································6

Auto-close setting················································12

TOOLS REQUIRED··································6

Installation direction setting·······································13

DOOR REQUIREMENTS·····························6

Lock door setting (Optional function) ······························13

TESTING THE DOOR································7

Half-open setting (Optional function) ······························13

INSTALLING THE STOP COLLAR·····················7

Alarm and maintenance function··································13

INSTALLING THE WEIGHT BAR (PROVIDED)··········7

TESTING THE SAFETY REVERSE SYSTEM·················14

THE RELEASE HANDLE & CORD·····················8

FIXING WARNING LABELS································14

OPERATING THE MANUAL RELEASE·················8

INSTALL THE IR BEAMS (OPTIONAL ACCESSORY) ········15

PINNING THE DOOR································9

INSTALL UNIVERSAL RECEIVER (OPTIONAL ACCESSORY) ·15

ATTACHING EXTENSION POLES (IF REQUIRED) ······9

INSTALL A FLASHING LIGHT (OPTIONAL ACCESSORY) ·····16

LEFT / RIGHT HAND INSTALLATION··················9

MAINTENANCE··········································16

INSTALLATION PROCEDURE·····················10-11

FINAL NOTES············································16

BASIC FUNCTION SETTING AND APPLICATION····11-13

IMPORTANT INFORMATION FOR THE USER················17

Pairing the receiver and transmitter·······················11

SPECIFICATIONS·········································17

Travel limit setting, Opening & closing force self-learning·······11

COMMON FAULTS & SOLUTIONS··························18

Safety reverse force adjustment····························12

Warranty Information ·····························19-20

- 6 -

3.DOOR REQUIREMENTS

The maximum allowable door height is 5.5m. The door must be of continuous corrugated sheet

construction and spring balanced. Door axle diameter must not exceed 35mm.

Ensure that there is at least 45 mm from the edge of the curtain to the edge of the bracket. If the

roller door drum is on the edge of the curtain or is a smaller diameter, additional clearance may be

required.

If the drum is more than 60 mm from the curtain edge or of a smaller diameter, an extension

pole kit may be required (section 10).

Ensure there is a suitable power point near the opener.

1.Packing List

Standard list ：

1.Rolling garage door opener X 1；

2.Remote control X 2；

3.Instructions X 1；

4.Clutch pull rope X 1；

5.Warning Label X 1；

Selection list：

1.Weight bar X 1;

2.Wall switch X 1;

3.Extension pole bag X 1;

2.TOOLS REQUIRED

Ladder

Socket wrench

Adjustable

Wrench

Drill

Marker Pen

13MM Socket

≥250MM Socket

Extension

Philips-head

Screwdriver

6.5MM Drill Bit