Jackco 66200B User Manual

MODEL 66200B

2 TON SUPER LOW PROFILE

FLOOR JACK

USER'S MANUAL

*This hydraulic jack conforms to all "ANSI / ASME" safety standards.

Jackco Transnational Inc. © 2014

Azusa. CA

888-452-2526

To see more jackco products please visit our website at www.jackco.com

FOR YOUR SAFETY

• The vehicle to be lifted should never exceed the rated capacity of the jack.

• The jack should be supported on a solid and level surface, which is well illuminated and free of

obstructions. Never use the jack in a surface at which it may sink into the ground.

• Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine and apply the brake.

Ensure the vehicle to be lifted against any type of sliding.

• Do not enter the vehicle or start the engine while it is supported on the jack or appropriate stands. The

jack is a lifting device only and should never be used to move the vehicle.

• Position the jack under the manufacturer’s recommended lifting point for the vehicle and ensure that it
is not corroded, dirty or greasy. This point should remain centered over the jack saddle. All off-centered

loads can slip and accidents may result.

• During raising and lowering of the load, all precautions should be taken to avoid movement of the vehicle
load. Trafc may cause the raised vehicle to rock during roadside use of the jack.

• The jack should be positioned so as to avoid the need of the user to introduce any part of his/her

body underneath the vehicle. Never work under a raised vehicle without previously supporting it with
mechanical/jack stands.

• Never position any part of your body near the movable parts of the jack.

• It is necessary for the operator to be able to observe the lifting process and the load’s movements. In
the presence of dangerous conditions, such as movement of the vehicle etc, the lifting process must be

interrupted.

• Ensure that there are no persons or obstructions underneath the vehicle prior to lowering.

• As an additional safety measure against overload, if the jack will not lift a load that is higher than the rated

capacity. A bypass valve set at the factory and which should not be adjusted under any circumstances.

Use wheel chocks appropriately

.

SPECIFICATION

Capacity: 2 ton Saddle Diameter : 4 in
Min Height : 2-3/4 in Strokes to Max Height: 8

Max Height : 24 in Net Weight : 94.25 lbs
Dimension: 32-1/2 in (L) x 14-1/2 in (W)

2

OPERATING INSTRUCTION

1. Prior to operating the jack, remove any accumulated air from the system as follows

(1) Insert the handle into the socket and secure it with the screw provided
(2) Pull the handle and turn it clockwise and whilst held in this position, pump the jack

several times to ensure internal lubrication and bleed the accumulated air from the
system.

2 Release the handle and it will automatically return back to the initial position. The jack is

now ready to be used.

Important: prior to lifting the load, ensure that all of the safety instructions are followed.

3. The wheel of the jacks should always be rotated freely.

4. The jacks are tted with a foot pedal that gives a faster approach to the load.

To Lift a Vehicle:

To Lower a vehicle:

Turn the handle clockwise.
Move the handle up and down. Use the full stroke of the piston for
greater speed.

Support the vehicle with appropriate jack stands.

Lift the vehicle to remove the jack stands, ensuring that there are

no persons or obstructions under the vehicle. Turn the handle

counter-clockwise.

5. The jacks are tted with 2 safety device that offers smooth and uniform lowering.

6. Once the vehicle had been lowered, release the handle and it will automatically return

back to the initial position

3