Jabra SP200 User Manual

SP200
Bluetooth® Wireless Speakerphone for Mobile Phones
SPEAK FREELY – DRIVE RESPONSIBLY
Drive carefully and take your calls with the in car Bluetooth® speakerphone
DATASHEET
The intuitive controls complement the unique user friendliness with a large easily accessible answer/end button, a volume wheel and a dedicated on/off switch. It’s as easy to operate as pulling down the visor.
The DSP voice processing technology delivers clear sounding details even in noisy environments. And the outstanding speaker perform­ance makes every call sound loud and bright.
Jabra’s SP200 long-lasting battery provides 10 hours of talk time and 23 days of standby time. It even comes with a car charge and a USB cable so you can charge both inside and outside your car.
Hands-free talking while driving simply doesn’t get easier.
Reasons to choose the Jabra SP200
In-car speakerphone for hands-free calls• Easy to use with no installation• Noise reduction and echo cancellation (DSP)•
Drive ‘n’ talk
WORD MARK AND LOGOS ARE OWNED BY THE BLUETOOTH SIG, INC. AND ANY USE OF SUCH MARKS BY GN NETCOM A/S IS UNDER LICENSE. (DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE)
®
THE BLUETOOTH
JABRA® IS A REGISTERED TRADEMARK OF GN NETCOM A/S
WWW.JABRA.COM
Quick Start Guide
Charge your speakerphone
Insert charger and remove when fully charged and the LED light turns green.
Turning your speakerphone on and off
Slide the on/off switch to turn the speakerphone on or off.
Pairing the speakerphone with your phone
First time pairing:
Turn the speakerphone on and it will automatically be in pairing mode. The blue LED light will flash rapidly.
Later pairing:
Turn the speakerphone on. Press and hold the answer/end button (approximately 5 sec) until blue light flashes rapidly.
Activate Bluetooth on your phone.
Search for Bluetooth devices and select Jabra SP200. Press “OK” on the phone and confirm with PIN code 0000 (4 zeros).
Using your speakerphone
Answer a call
Tap the answer/end button on your speakerphone to answer a call.
End a call
Tap the answer/end button on your speakerphone to end an active call.
Make a call
The call will automatically transfer to your speakerphone. If not tap the answer/end button.
Reject a call*
Press the answer/end button.
Activate voice dialing*
Press the answer/end button. For best results, record the voice-dialing tag through your speakerphone.
Redial last number*
Double tap the answer/end button when the speakerphone is on and not used.
Mute/un-mute
Press the answer/end button to mute an active call. A beep tone plays during the muted call. Press the answer/end button to un-mute.
Adjust sound and volume
Scroll the volume wheel to the left or right to adjust the volume.
Sleep mode
When disconnected from the phone, the speakerphone turns off automatically after 15 minutes. Tap answer/end button to turn the speakerphone on again.
Place the jabra SP200 in your vehicle
The Jabra SP200 sits discreetly and conveniently on the sun visor.
*Phone dependent
4
2
5
7
1
3
6
1) Answer/end button
Tap button to answer or end call
2) LED light
Shows status of the speaker­phone
3) Charging socket
Easy charging with USB and car charger power supply provided.
4) Volume wheel
Scroll the volume wheel to the left or right to adjust the volume
5) On/off switch
Slide the on/off switch to turn the speakerphone on or off.
6) Speaker
For powerful and clear sound quality
7) Microphone
For optimized sound quality in receiver end.
Features and Specifications
1. In-car speakerphone for hands-free calls
2. Easy to install and use
3. Noise reduction & echo cancellation
4. Answer/end calls
5. Reject calls*
6. Voice dialing*
7. Last number redialing*
8. Mute
9. Auto pairing
10. Auto off
11. 10 hours talk time
12. 23 days stand by time
13. Full duplex
14. Bluetooth 2.0 with eSCO supporting headset and hands-free profile
15. Weighs 3 oz.
16. L4.8in x W2.2in x D0.9in
17. Comes with USB cable, car charger and clip for visor
JABRA® IS A REGISTERED TRADEMARK OF GN NETCOM A/S
WWW.JABRA.COM
Loading...