Invacare IRC5P2, IRC5P User Manual

HomeFill™Ready Rack for Perfecto2™

Concentrator

Assembly, Installation and Operating Instructions

Model No. - For use with IRC5P and IRC5P2

SAVE THESE INSTRUCTIONS

NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact the Carrier/
Invacare for further instruction.

Safety Summary

 WARNING

DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the Warnings, Cautions and
Instructions in this instruction sheet contact your Home Healthcare Dealer before
attempting to install this equipment – otherwise injury or damage may result.

DO NOT move the concentrator while the HomeFill compressor is on the ready
rack. Separate the HomeFill compressor from the ready rack prior to transporting.

Children should ALWAYS be supervised around the HomeFill unit. When used with
the HomeFill ready rack or similar elevated support surfaces, a child could pull over
any such stand causing the unit to fall. Failure to observe this warning may result in
personal injury or product damage.

Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.

CAUTION

The HomeFill ready rack is designed for use with the Invacare Perfecto2
concentrator and Invacare HomeFill compressor only. DO NOT attempt to use this

ready rack with other products. Otherwise, damage to the ready rack and/or the
other devices may occur.

Assembly

The HomeFill ready rack requires no assembly and is provided in a ready for use
condition.

For more information regarding Invacare products, parts, and services,

please visit www.invacare.com

Part No 1148363 1 HomeFill™Ready Rack for Perfecto2™

Installing the HomeFill Ready Rack

NOTE: For this procedure, refer to FIGURE 1 on page 3.

1. Position the Invacare Perfecto2 concentrator in the desired location.

2. Align the HomeFill ready rack above and toward the rear of the concentrator (Detail
“A”).

3. Move the ready rack forward until the rear pins fully engage the concentrator
mounting holes (Detail “B”).

4. Rotate the latch down over the handle to secure in place (Detail “B”).

5. Orient and place the HomeFill compressor onto the installed ready rack as shown
(Detail “C”).

NOTE: The HomeFill compressor will prevent the latch from becoming unsecured.

6. Connect the HomeFill fill hose to the concentrator and compressor. Refer to Perfecto2
owner’s manual, part number 1143482, for proper connections.

Transporting

 WARNING

DO NOT move the concentrator while the HomeFill compressor is on the ready
rack. Separate the HomeFill compressor from the ready rack prior to transporting.

1. Disconnect the HomeFill unit from the concentrator and remove unit from the ready
rack prior to transporting.

NOTE: For operating instructions of the concentrator and/or HomeFill compressor, refer to
Perfecto2 owner’s manual, part number 1143482, or HomeFill owner’s manual, part number

1100873.

HomeFill™Ready Rack for Perfecto2™ 2 Part No 1148363