Intermatic T106M Owner's Manual

MODEL: T106M

24 HR. DIAL TIME SWITCH (DPST)

ONE NORMALLY OPEN - ONE NORMALLY CLOSED CONTACTS

40 AMP. RESISTIVE, INDUCTIVE TUNGSTEN
OR 1000V.A. PILOT DUTY PER POLE 120-277V. AC;
2 H.P. (24 FLA) - 120 V. AC; 5 H.P. (28 FLA) - 240V. AC

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO
ORDER REPLACEMENT, INDICATE PART NO. (WG--) ON MOTOR COVER.

CLOCK
DIAL

TIME
POINTER

OFF

TRIPPER
MANUAL
LEVER

WIRING INSTRUCTIONS: To wire switch follow diagram above. To wire as SINGLE
POLE NORMALLY CLOSED, move clock motor lead from terminal 3 to 1, and

connect LINE to 1, LOAD to 2. To wire as SINGLE POLE DOUBLE THROW,
install jumper (the same gauge as line wire) between 2 and 3 and connect

LINE to 2, LOADS to 1 and 4. NOTE: Line 2 if present is uninterrupted. Use
COPPER wire only. for gauge selection and wire connection, see details below.

Use 3/16 or larger screwdriver, tighten terminal screws firmly (25 lb-in minimum).

REPLACE INSULATOR BEFORE TURNING ON ELECTRICITY.

MINIMUM

COPPER

WIRE SIZE

(AWG)

14
12
10

8

PROGRAMMING INSTRUCTIONS

•TO SET “ON” AND “OFF” TIMES: Hold trippers
against edge of CLOCK-DIAL, pointing to time (AM or
PM) when ON and OFF operations are desired,
tighten tripper screws firmly. For additional tripper pairs
on CLOCK-DIAL order 156T1978A.

•TO SET TIME-OF-DAY: Pull CLOCK-DIAL outward.
Turn in either direction and align the exact time-of-day
on the CLOCK-DIAL (time now, when switch is put into
operation) to TIME POINTER. DO NOT MOVE

POINTER.
OPERATING INSTRUCTIONS

•TO OPERATE SWITCH MANUALLY: Move MANUAL
LEVER below CLOCK-DIAL left or right as indicated by
arrows. This will not effect next operation.

•INCASEOF POWER FAILURE, reset CLOCK-DIAL to
proper time-of-day. See programming instructions.

158TS13233

CLOCK MOTOR: 208-277V. 60 HZ.

ON
TRIPPER

FIGURE 1

MAX.

MIN.

LOAD

INSUL-

(AMP)

ATION

TEMP (°C)

15

60

20

60

30

60

40

75

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

FROM

208V
240V

OR

277V

SUPPLY

TYPICAL WIRING SINGLE POLE NORMALLY OPEN
SEE WIRING INSTRUCTIONS BELOW FOR OTHER TYPES

75° INSULATION MAX. MOTOR

LOAD (HP)

SINGLE PHASE

120V 240V

1/2

1
2

2 1/2

2

3
5

240V 240V

N/A

GRD

N

LINE

3 PHASE

N/A

CLOCK
MOTOR

A

WIRING DIAGRAM

4321

GROUND

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE
INSULATION CLEARS
PRESSURE PLATE

TO
LOAD