Intermatic T101R Owner's Manual

MODEL: T101R

24 HR DIAL TIME SWITCH (SPST)

IN TYPE 3R DUSTPROOF RAINPROOF ENCLOSURE SUITABLE FOR POOL
EQUIPMENT CONTROL IF INSTALLED 5FT. OR MORE FROM EDGE OF POOL.

40 AMP. RESISTIVE, INDUCTIVE, TUNGSTEN
OR 1000 VA PILOT DUTY 120/208/240 VOLT AC;
2 HP (24 FLA) - 120V AC; 5 HP (28 FLA) - 240V AC

WIRING INSTRUCTIONS: To wire switch follow diagram above.

Use solid or stranded COPPER only wire with insulation to suit
installation. See gauge selection table for normal service applica­tions.To make power connections remove 1/2 inch of insulation
from wire ends. Insert bare ends of wire under the pressure plate
of terminals. Use 3/16 or larger screwdriver to tighten terminal
screws firmly. (25 lb-in minimum).
REPLACE INSULATOR BEFORE TURNING ON ELECTRICITY.

PROGRAMMING INSTRUCTIONS

1. TO SET “ON” AND “OFF” TIMES: Hold trippers against edge
of CLOCK-DIAL, pointing to time (AM or PM) when ON and
OFF operations are desired, tighten tripper screws firmly. For
additional tripper pairs on CLOCK-DIAL order 156T1978A.

2. TO SET TIME-OF-DAY: Pull CLOCK-DIAL outward. Turn in
either direction and align the exact time-of-day on the CLOCK-
DIAL (the time now, when switch is being put into operation) to
the pointer. DO NOT MOVE POINTER.

OPERATING INSTRUCTIONS

• TO OPERATE SWITCH MANUALLY: Move MANUAL
LEVER
below CLOCK-DIAL left or right as indicated by arrows. This

will not effect next operation.

• IN CASE OF POWER FAILURE, reset CLOCK-DIAL to
proper time-of-day. See programming instructions.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

158TS10914

TIME
POINTER

TIME
DIAL

OFF
TRIPPER

MANUAL
LEVER

ON
TRIPPER

LINE

NEUT.

CLOCK
MOTOR

GROUND

A

1

2

GRD.

120V

SUPPLY

TO
LOAD

WIRING
DIAGRAM

CLOCK MOTOR: 110-125 VOLTS - 60 HZ.

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO
ORDER REPLACEMENT, INDICATE ART NO. (WG--) ON MOTOR COVER.

LR3730

MINIMUM

COPPER

WIRE SIZE

(AWG)

MAX.
LOAD
(AMP)

MIN.

INSUL-

ATION

TEMP (°C)

75°C INSULATION MAX. MOTOR

LOAD (HP)

SINGLE PHASE 3 PHASE

120 V. 240 V. 208 V.

240 V.

14
12
10

8

15
20
30
40

60
60
60
75

1/2

1
2

-

2

2 1/2

3
5

N/A

N/A

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE
INSULATION CLEARS
PRESSURE PLATE

158TS10914 1 4/15/09 4:49:53 PM