Interlogix Simon XTi User Manual

Simon XTi Designer Template Installation Sheet

Figure 2: Panel cover

Introduction

The designer template is the adhesive-backed plastic template
that covers the front of the Simon XTi panel.

Caution: The authorized designer template and its installation

are integral parts to the reliability of the system. Replacement
of the authorized designer template should be done by the
security system installer.

Installation

Removing the designer template

1. Remove all power (both battery and AC). Use proper ESD
protection practices when replacing the designer template.

2. Remove trim ring from the panel by lifting at notch (D in
Figure 2 below).

3. Lift a corner of the template and peel back until it is
removed from the front of the panel.

Installing the designer template

Figure 1: Designer template front

B

C

D

1. Before installing a designer template, ensure that both the
display screen and cover surface are free of any lint. Wipe
the surface down with a lint-free cloth.

2. Turn over the template to the back side (paper-backed
adhesive side).

3. Position the template so the two alignment holes (A in
Figure 1 above) are vertically located on your left side.

4. Starting at one of the left hand corners, partially peel back
the paper backing about 2 -3 inches to the right (F in
Figure 3 on page 2) exposing both of the two alignment
holes (E in Figure 3 on page 2). Crease and flatten the
partially removed paper backing against the back of the
template.

A

422-5136-05

P/N 466-2460 • REV B • 08FEB13 1

Figure 3: Designer template back

F

E

5. Turn over the template to the front (cosmetic) side.

6. Position the two alignment holes in the template (A in
Figure 1 on page 1) over the two pins (C in Figure 2 on
page 1) located on the cover of the panel.

7. Lightly press down on the left side of the template. Once
located, reach under the template and remove the
remainder of the paper backing (F in Figure 3 above).

8. Press down with your thumb on the template from left to
right, removing any air bubbles and ensuring proper
adhesion.

9. After the template is adhered to the front of the panel,
remove protective film from front of template by pulling on
tab (B in Figure 1 on page 1) in upper right hand corner.

10. Replace the plastic trim ring on panel.

Contact information

www.utcfireandsecurity.com or www.interlogix.com

For customer support, see www.interlogix.com/customer-

support

© 2013 UTC Fire & Security Americas Corporation, Inc.
Interlogix is part of UTC Climate Controls & Security,
a unit of United Technologies Corporation. All rights reserved.

2 Simon XTi Designer Template Installation Sheet