Intel ND15 User Manual

Installation Addendum – FCC ID: 2AB8ZND15

This module is approved for use with the antennas described in the Digi manual,
XBee-PRO 900HP/XBee-PRO XSC RF Modules User Guide, page 181, when
installed so that the end device and antennas are a minimum of 20cm from
persons. RF exposure information needs to be included in the end product’s user
manual to ensure installation in accordance with these conditions.

Use in such portable conditions is limited to devices manufactured by Intel or by
ODMs. The device shall be installed onto a ski, snowboard or similar device such
that the device is located at least 39mm from wrists, ankles, feet and
hands. Installation instructions and user information must clearly reflect this and
the instructions must indicate that this separation distance is required to ensure
compliance with RF exposure requirements.

The host equipment into which the module is installed must be labelled with the
following visible to the user:

Contains FCC ID: 2AB8ZND15

Intel Corporation

2200 Mission College Blvd
Santa Clara, CA 95054