Insignia NS-S6901 User Manual

User Guide

6'' × 9'' Car Stereo Speakers

NS-S6901

Insignia NS-S6901

6'' × 9'' Car Stereo

Speakers

Introduction

Congratulations on your purchase of a
high-quality Insignia product. Your NS-S6901
Car Stereo Speakers represent the state of the
art in car speaker design, and are designed for
reliable and trouble-free performance.

• Mounting screws (8)

• Mounting clips (8)

Dimensions

4.76 in

(121 mm)

7/26 in

184.5 mm)

0.177 in
(4.50 mm)

Safety information

•This

• Do not install the speakers where they may

• To prevent a short circuit, never leave any

• Make absolutely sure that the positive (+) and

• Never run the wiring on the outside of, or

• When your speakers are connected, turn on

• Do not overload the speakers beyond their

• Keep recorded tapes, watches, and personal

• If you cannot find an appropriate mounting

User Guide

contains important
instructions for your safety. Make sure that
you refer to it.

be subjected to excessive heat, moisture, or
dust, or where they will be kicked repeatedly,
brushed, or bumped.

metal objects, such as coins or metal tools,
inside the acoustic system.

negative (-) terminals of the speakers are
connected to the correct outputs from the
music source.

under, the vehicle, where it can be damaged
by road hazards or moving parts of the
vehicle. Use existing wire channels, sills,
panels, and moulding strips inside the vehicle
to hide the wiring for safety and a neat
appearance.

the various components and slowly turn up
the volume. Make sure that you check and
double-check all connections to insure
correct installation and use.

nominal power handling capacity.

credit cards using magnetic coding away
from the speakers to protect them from
damage caused by the magnets in the
speakers.

location, consult your car or sound system
dealer before mounting.

6.57 in
(167 mm)

10.35 in
(263 mm)

3.89 in

(99 mm)

3.13 in

(79.5 mm)

4.72 in
(120 mm)

8.74 in
(222 mm)

Troubleshooting

Always test the speakers and speaker wires.
Make sure that the speakers are connected with
the correct polarity (positive (+) amplifier output
to positive (+) speaker terminal and negative (-)
amplifier output to negative (-) speaker terminal).

Specifications

6.02 in

(153 mm)

Warning

• Before mounting the speakers and connecting

• Use extreme caution when working near the

Features

Included:

• 6'' × 9'' speakers (2)

• Speaker wire mounting leads

the wires, make sure that the negative battery
cable is disconnected from the battery. Failure
to do this may cause a short circuit or fire.

gas tank, gas lines, or hydraulic lines with
electrical wiring.

www.insignia-products.com

Frequency 60-20 kHz

Sensitivity 90dB/W/M

Peak power 150 W

Magnet 30 oz.

Voice coil 1.38 in (35 mm)

Woofer Electroplate IMPP cone

Midrange and
Twe et er

Impedance 4 ohms

2.28 in (58 mm) Mylar dome tweeter, 1.18 in
(30 mm) Mylar dome tweeter, and .78 in
(20 mm) piezo tweeter

3