INGENICO ELITE770IB, ELITE770HH Users Manual

Elite 770 User’s Manual

US Federal Communication Commission (FCC) Warnings:

This equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the followin g measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Warning : Changes or modifications not expressly approved by IVI Checkmate Inc. could void the user’s authority to operate the equipment.
Telephone Connection Requirements: This equipment complies with Part 68 of the FCC rules. On the bottom of this equipment is a label that contains, among other

information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone
company.

An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises
wiring using a compatible modular jack which is Part 68 compliant. See installation instructions for details.

The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices
not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may
be connected to a line, as determined by the total RENs, contact the local telephone company.

Incidence of Harm: If the terminal equipment Elite 770 causes harm to the telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.

Changes in Telephone Company Equipment or Facilities: The telephone company may make changes in its communications facilities, equipment, operations or
procedures, where such action is reasonably required and proper in its business. Should any such changes render the customer’s terminal equipment incompatible with
the telephone company facilities the customer shall be given adequate notice to the effect the modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, Elite 770, for repair or warranty information, please contact:

If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
There are no user serviceable parts inside.
General: This equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs.
(Contact the state public utility commission, public service commission or corporation commission for information.)

• Consult the dealer or an experienced radio/TV technician for help.

USOC Jack: RJ-11

IVI Checkmate Inc.

TotalCARE
1335 North Meadow Parkway
Suite 116
Roswell Ga 30076

Tel : 1-800 - 435-3014
Contact : Service Department

Elite 770 User’s Manual

Industry Canada Warnings:

This digital apparatus does not exceed the Class A limit for radio noise emissions from the digital apparatus as set out in the radio interference regulations of the
Industry Canada.

NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective,
operational and safely requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.

Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if
present, are connected together. This precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, or electrician, as
appropriate.

NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be
connected to the telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the
Ringer Equivalence Numbers of all the devices does not exceed 5.