Infinity OVTR 3, OVTR 2 User Manual
®
Models OVTR 2, OVTR 3
3-Way Full-Range Floorstanding Speakers
Owner’s Manual
OVTR 2 Part #331250 – USA 120 Vac Only
OVTR 3 Part #331251 – USA 120 Vac Only
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended
to alert the user to the presence of
uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the product.
THIS INFINITY PRODUCT IS DESIGNED FOR (USA) 120 VOLT USE ONLY!
FOR DETAILED SAFETY PRECAUTIONS, PLEASE SEE THE ENCLOSED
LEAFLET “IMPORTANT SAFETY INSTRUCTIONS” (P/N 330100-001).
INTRODUCTION
3-WAY FLOOR-STANDING
SPEAKERS WITH
INTEGRATED POWERED
SUBWOOFERS...
BOUT THIS MANUAL...
A
Infinity Compositions Overture OVTR 2 and OVTR 3 speaker systems
are a pair of advanced, 3-way full-range, floor-standing speakers with
integrated powered subwoofers. Housed in slender columns, these
highly-efficient speakers require only minimal power to produce sound
levels greater than those heard in a movie theater. Moreover, even
though they excel at reproduction of front left and right home-theater
channels, you’ll find these speakers also provide the highest musical
fulfillment when listening to CDs, LPs, or tapes.
To start enjoying your new Compositions Overture speakers, first read
and then perform all instructions listed in this manual, as well as those
found in the owner’s manuals of associated components in your audio system.
Also, please read the enclosed Important Safety Instructions for detailed
safety precautions. Save all instructions for future reference. These speakers
are covered by a limited five-year warranty (see page 12), so save the bill of
sale to protect your purchase and aid in any service-related questions.
UNPACKING THE SPEAKERS
Finish unpacking each speaker box. If you suspect damage from transit,
report it immediately to your dealer and/or delivery service. Keep the
shipping cartons and packing materials for future use. Open each
accessory pack and verify the following contents:
ARTS LIST...
P
OOLS AND SUPPLIES
T
(NOT ENCLOSED)...
◆
(4) Feet
◆
(4) Locking Nuts
◆
(4) Nylon Domes
◆
(1) Wrench
◆
(2) Spare 5 A (250 V) Fuses for OVTR 2 or
(2) Spare 5A (250V) Fuses for OVTR 3
◆
Owner’s Manual (P/N 331350-001) and Warranty Registration Card
You may also need the following tools and supplies:
◆
High-quality speaker wire (also see Wiring The System on page 5)
◆
Wire strippers
◆
Small flat-blade screwdriver (for fuse replacement, if needed)
◆
(4) Banana plugs or spade terminals (optional)
◆
Level (optional for adjusting feet)
Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual ◆1
INSTALLING THE FEET
~120V 60Hz
300W MAX
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
CAUTION:
FOR CONTINUED PROTECTION AGAINST
RISK OF FIRE, REPLACE ONLY WITH SAME
TYPE OF FUSE: 2AG SB 250V
ATTENTION:
UTILSER UN FUSIBLE DE
RECHANGE DE MEME
TYPE ET CALIBRE
F
U
S
E
F
U
S
E
Foot HoleFoot Hole
Fuse Holder
OVTR 2 or
OVTR 3
(bottom view)
Foot HoleFoot Hole
120 Vac Power Cord
Cord Channel
Speaker
Port
Compositions Overture OVTR 2 and OVTR 3 speakers use dual-purpose
feet with spike and round ends for carpeted or hard-surface floors. Refer
to Figures 1 and 2 as you perform the following steps:
1. Lay each speaker on its side and locate the four threaded holes on
the bottom (see Figure 1).
IMPORTANT!
Figure 1. This bottom view shows the
four locations of the foot holes
and the ac cord channel on a
Compositions Overture OVTR 2
or OVTR 3 speaker.
NOTE: Do not unfasten any screws.
There are no user-serviceable parts
inside the speaker. For service, please
contact an authorized Infinity
technician for help (also see
“Troubleshooting” on page 8 and
“Limited Five-Year Warranty” on
page 12).
For safety reasons, each speaker base contains a cord channel
designed to keep the ac power cord away from the feet. During
shipping, the cord may become dislodged from its intended
position and upon subsequent speaker placement may be
accidentally pierced by spiked feet. Please make sure that the
120 Vac power cord is inside the cord channel (see Figure 1).
◆
2
Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual
Figure 2. This cross-section shows
Nylon Dome
(optional for
wood floors)
Locking Nut
HARD-SURFACE
FLOORS
CARPETED
FLOORS
Foot
round end
spike end
Bottom
Of Speaker
5
⁄8"
5
⁄8" min.
1
1
⁄8" max.
how to install a foot onto the bottom
of a Compositions Overture OVTR 2
or OVTR 3 speaker.
2. For carpets, screw the round end of a foot into each hole and handtighten a nut onto each one (see Figure 2). Leave a minimum of
5
⁄8"
exposed spike to keep the carpet from blocking the port. (On thicker
carpets, you can increase the length of exposed spike up to 1
1
⁄8 ").
For hard-surface floors, screw the spike end into each hole instead
and leave
5
⁄8" of round end exposed.
3. Carefully flip each speaker upright to sit on its feet.
4. If needed, adjust the feet so each speaker is level and then tighten
each nut with the enclosed wrench. To protect hard surfaces (e.g.,
wood floors), thread a nylon dome onto each round end (see Figure 2).
Compositions Overture OVTR 2/OVTR 3 – Owner’s Manual
◆
3
Loading...