Infinity Entra Series, Entra One, Entra Center, Entra Center Two, Entra Three Owner's Manual

The Entra Series of loudspeakers continues Infinity’s
longstaiiding commitment to accurate sound reproduction,
Our patented Ceramic Metal Matrix Diaphragm” (C.M.M.DY’)
drivers, precision dividing networks, and rigid, well-braced
enclosures combine to deliver uncompromised performance in
any stereo or multichannel home-theater system. In addition,
Entra Series speakers are magnetically shielded for safe
placement adjacent to a television.

If you suspect damage from transit, report it immediately to
your dealer. Keep the shipping carton and packing materials
for future use,

Before deciding where to place your Entra speakers, survey your
room and think about placement, keeping the following points
in mind, using Figure 1 as a guide:

B For best results, place the speakers 6’- 8’ apart.

0 Position each speaker so that the tweeter is approximately at

ear level.

* Generally, bass output will increase as the speaker is moved

closer to a wall or corner.

* Refer to “Home Theater” below if you also plan to use the

speakers for home-theater reproduction,

use, place one speaker on the left and another

on the right along either side of the television monitor, Since the

speakers are magnetically shielded, you can place them without
worrying about the field distorting the TV picture.

For rear-channel use, place Entra One speakers on bookshelves
or stands - or Entra floorstanding speakers on the floor­alongside the listening position. Final placement depends on
room acoustics, availability of space and your listening
preference (Figure 2).

The center channel speaker should be placed on top of or
directly below the television and aimed towards Ihe listening area.

TE: An Infinity powered subwoofer will add impact and
realism to both music and film soundtracks. Contact your Infinity
dealer for recommendations on subwoofer models for your

application.

Refer to Figure 4 as you perform ttic following steps:
‘I. ‘The Entra’bo and EntraThree come with the round end of

their feet exposed for use on hard-surface floors.To expose
the spiked end of the feet, lay each speaker on,its side and
use the enclosed wrench Lo unscrew and remove the Four
feet. Screw the round end of each foot into its hole and
hand-tighten a nut onto each foot. Leave a minimum of 5/S”
of exposed spike. (On thicker carpets, you can increase the
length of exposed spike up to lJ/8:‘)

2. Carefully stand each speaker upright to sit on its feet.

3. If needed, adjust the feet so each speaker is level and then
tighten each nut with the enclosed wrench,