Page 1
Quick guide
EN
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on www . indesit . com/ register
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting
the appliance to the power supply. Connect the appliance to the
power supply it starts the operation automatically. The ideal storage
temperatures for the food are preset in the factory.
CONTROL PANEL
2.
1.
Before using the appliance carefully read the Safety
Instruction.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available). If the audible signal
sounds, it means that the temperature alarm has intervened: press the
button to switch o the acoustic alarms.
1. LED Light
2. On/Stand-by
3. Freezer and refrigerator compartment
temperature button
3.
ON/STANDBY
Press the button for 3 seconds to turn the appliance o. In
Stand-by mode the light in the refrigerator compartment does not turn
on. Press the button again briey to reactivate the appliance.
Note: this does not disconnect the appliance from the power supply.
FREEZER AND REFRIGERATOR
COMPARTMENT TEMPERATURE
The three LED indicators indicate the refrigerator compartment set
temperature.
It is possible to set a dierent temperature of the appliance with the
button.
The following adjustments are possible:
LEDs lit Set temperature
High (less cold)
Medium-high
Medium
Medium-low
Low (colder)
FAN*
You can turn the Fan on/o by pressing the button on the base (as
shown in the gure). If the ambient temperature exceeds
27°C, or if drops of water are present on the glass shelves,
it is essential that the fan is on to ensure the proper
preservation of the food. Deactivation of the fan allows
energy consumption to be optimised.
FREEZING FRESH FOOD
Place the fresh food to be frozen in the FREEZING ZONE in the freezer
compartment avoiding the direct contact with the food that is already
frozen. To optimize the freezing speed, the lower drawer can be
removed and the food can be placed directly on the bottom of the
compartment.
* Available only on certain models
Page 2
STOP FROST SYSTEM*
The STOP FROST SYSTEM facilitates the defrost procedure for the
freezer compartment.
The STOP FROST accessory is designed to collect some of the frost
that forms in the freezer compartment and it is easy to remove and
clean, therefore reducing the time needed to defrost the freezer
compartment.
PROCEDURE TO CLEAN THE STOP FROST ACCESSORY
1. Open the freezer compartment door and remove the upper
drawer.
Unfasten the STOP FROST accessory and remove it, taking care not
2.
to drop it on the glass shelf below.
Note: if the accessory is jammed or dicult to remove, do not keep
trying to remove it, but proceed with the complete defrost of the freezer
compartment.
Close the door of the freezer compartment.
3.
4. Remove the frost on the accessory by rinsing it under running (not
hot) water.
To remove the frost on the STOP FROST accessory follow the cleaning
procedure demonstrated below.
5. Let the accessory drip dry and dry the plastic parts with a soft
cloth.
Reinsert the accessory by placing the back part on the projections
6.
shown in gure, then refasten the handle of the accessory to the
clasps above.
Reinsert the upper drawer and close the door of the freezer
7.
compartment.
It is possible to clean the STOP FROST accessory on its own without
completely defrosting the freezer compartment.
Cleaning the STOP FROST accessory regularly helps to reduce the need
to completely defrost the freezer compartment.
Note: the product specications, including volume and energy, are
calculated without the STOP FROST accessory.
HOW TO STORE FOOD AND BEVERAGE
**
***
** For models with "0 ° ZONE" COMPARTMENT the "coolest area" is the one
highlighted in the legend
*** Only for CB310 e CB380 models (refer to the Rating plate located at side
of Fruit and vegetable drawer)
Legend
TEMPERATE ZONE
Suggested for storage of tropical fruit, cans, drink, eggs,
sauces, pickles, butter, jam
COOL ZONE
Suggested for storage of cheese, milk, daily food,
delicatessen, yoghurt
COOLEST AREA
Suggested for storage of cold cuts, desserts, meat and
sh
FRUIT & VEGETABLE DRAWER
FREEZER DRAWERS
FREEZING ZONE DRAWER
(Max cool zone)
Suggested to freeze fresh/cooked food
* Available only on certain models
Page 3
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The control panel is
switched o, the appliance
does not work.
The inside light does not
work.
The inside light ashes. Door alarm active.
The temperature inside the
compartments is not low
enough.
There is water on the
bottom of the refrigerator
compartment.
Excessive amount of frost in
the freezer compartment
There may be an appliance power
supply problem.
The appliance could be in On/stand by
mode.
The light may need to be replace.
Malfunction of a technical component.
It is activated when the refrigerator
compartment door remains open for a
prolonged period of time.
There could be various causes (see
“Solutions”).
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
The door of the freezer compartment
does not close properly.
Check that:
• there is not a power outage;
• the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i.e. allows
the appliance to be powered);
• the household electrical system protection devices are ecient;
• the power cable is not damaged.
Turn the appliance on by briey pressing the “Te mp.” button (see On/
Stand-by function).
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
Check that:
• the doors close properly;
• the appliance is not installed near a heat source;
• the set temperature is adequate;
• the circulation of air through the vents at the bottom of the
appliance is not obstructed (see installation section).
Maintenance").
• Check that there is nothing preventing the door from closing
properly.
• Defrost the freezer compartment.
• Make sure the appliance has been correctly installed.
The front edge of the
appliance, at the door striker
seal, is hot.
One or more green symbols
are ashing continuously
and it is not possible to
change the temperature set.
The temperature of the
refrigerator compartment is
too cold.
* Available only on certain models
This is not a defect. It prevents
condensation from forming.
Malfunction alarm.
The alarm indicates a fault in a technical
component.
• The set temperature is too cold.
• A large amount of fresh food may
have been placed in the freezer
compartment.
No solution is necessary.
Contact Technical Assistance Service.
• Try to set a less cold temperature.
• If fresh food has been placed in the freezer compartment, wait
until it has fully frozen.
• Turn o the fan (if present) following the procedure described in
the paragraph “FAN”.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website docs . indesit . eu
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
400011220265
Loading...