Contents - Make sure that the package contains the following parts:
I
J
POWER
HEAT
HIGH
INTENSITY
PULSE
LOW
PRESS
WAVE
MODE
AUTO
NORMAL
BACK
LUMBAR
THIGH
LEG
15Min
30Min
60Min
TIMER
Contents - Make sure that the package contains the following parts:
x 6
M8 x 3 0mm
x 6
S6
Assembly Instructions
Step 1: Turn the star base upside down, then press the casters into
the holes at the end of each base leg
Step 2: Turn the star base upright and insert the lift into the center
hole of the star base. The lift cover should be placed over
the lift.Pay attention to the placing order of the three cups,
and place them correctly as shown in the figure
Step 3: Align the seat plate over the pre-drilled holes underneath
the seat cushion. Make sure that the front of the seat plate
is facing the front of the seat cushion. Attach the seat plate
to the seat cushion using four M6x20mm bolts. Tighten all
the bolts with the wrench, being careful not to miss-thread
the bolts or damage the seat.
Step 4：Please use f our M6*25 screw s to connect the ba ckrest, tighten all the
screws with a wre nch, and be careful not to miss the screws or damage
them.
Step 5：Tu rn the seat cushion upright and align the center hole of the seat plate
over the lift, th en push the seat cu shion down onto t he lift firmly until the
connection is s ecure.
x 6
x 6
Step 6：Attach the a rms to the seat cus hion with four M8x30mm bolts, using the
wrench.Note : Arm rests are labeled with an "L" (left) or "R" (right) to show
which sides the y should be place d on.
x 6
Step 7：Press the pl astic caps into t he arm holes to cov er the bolts.
Step 8：Adjustin g the seat height To raise your seat, p ull up the
control handl e. To lower the seat, pull down th e control
handle.
Step 9：Adjust thi s handle to make th e chair tilt back . If the handle
is pulled downw ard, the chair wi ll not move. If the handle is
balanced, it wi ll be unlocked. P lease pay attention to the
adjustment.
9
Step 10：Adjusti ng the tilt tensi onTurn the tilt knob clockwise to
make it easier to r ock your chair backwards.Turn the
tilt knob count erclockwise to make it harder to rock your
chair backwar ds.Note: If your chair won't tilt back, pull
out the control h andle.
WARNING• Use care wh en handling.• Please read th e instructi ons
completely before assemb ly.• Remov e all parts fro m the carton and
ensure all parts are include d prior to assembly.• Assemble the chair
on the carton or carpet to preve nt scratching the chair.• Be careful
not to cross-thread bolts. • Do not use power tools.• For your safety,
before using your chair, make s ure that all of the bolts are fully
tightened. Keep the enclos ed wrench and check the bolts periodicall y
to make sure they remain secur ely tightened.
Loading...