IBM E12, E24 User Manual

8271 N

WAYS

E

THERNET

LAN S

WITCH

Package Contents

User’s Guide

M

ODELS

Q

UICK INSTALLATION

Quick Reference Guide

E12

1x

13x

Status

green

=enabled,linkOK

flashinggreen

=disabled,linkOK

off

=linkfail

5

334

667788991010111112

112

5

4

2

131314

17

151516

18181919202021212222232324

14

17

16

E24

Module

10BASE-T/100BASE-TX

Packet

12

Status

25 26 PacketPacket

24

25 26 Status

Status

25x 26x

AND

6x 7x

18x 19x

12x

TCVR

24x

8271 Model E12 (02L0876)
8271 Model E24 (02L0877)

Release Notes

G

UIDE

Unit

2

1
3

4
6

5

Power/Self test

8

7

Quick Installation
Guide

Management

Guide

Version 2.0

CD-ROM

4 x rubber feet

2 x mounting brackets and 6 x fixing

Installing the Switch

DANGER: SD21-0030.

The User’s Guide also contains further information
on the following steps.

Installing into a 19-inch Rack

Fit the brackets as shown in the figure below to
each side of the unit. Following the manufacturer’s
instructions, secure the unit into the rack.

You must use the screws supplied with the mount­ing brackets. Damage caused to the unit by using
incorrect screws will invalidate your warranty.

DANGER:

It is essential that the mains socket
outlet is installed near to the unit and is accessi­ble. You can only disconnect the unit by removing
the appliance coupler from the unit.

The Switch powers-up and runs through its Power
On Self Test (POST), which takes approximately 12
seconds. When the POST is complete, check the
Power/Self Test LED to see that your Switch is oper­ating correctly.

Color State

Green The Switch is powered-up and operating normally.

Yellow The Switch has failed its POST.

Off The Switch is not receiving power.

Further Information

You can find further information about installing

■

and powering-up the Switch in the

Nways Ethernet LAN Switch Model E12 and E24
User’s Guide”

For information about setting up the Switch for

■

management, refer to Chapter 2 of the IBM Nways
Ethernet LAN Switch Management Guide.

.

“IBM 8271

Powering-up the Switch

Plug the power cord into the power socket at the rear of

1

the Switch.

Plug the other end of the power cord into your power

2

outlet.

Part Number: 35L2182

Published: January, 1999