24" WIDE LCD MONITOR
Model : P240W
24" WIDE LCD MONITOR
Model : P240W
User Instructions
The Federal Communications Commission Radio Frequency Interference Statement includes the
following warning :
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in are
sidential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to
radiocommunications. However, there is no guarantee that interference will not occur in
a particularinstallation.
If this equipment does cause harmful interference to radio or television receptions, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures :
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/TV technician for assistance.
User Information
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.Connecting of peripherals requires the use of
grounded shielded signal cables.
1
FCC Information
Correct placement and adjustment of the monitor can reduce eye, shoulder, and neck fatigue.
Check the following when you position the monitor.
Keep the top of the monitor screen slightly below eye level. Your eyes should
look slightly downward when viewing the middle of the screen.
Correct posture for efective use of the LCD monitor.
Placement
Components
Position your monitor no closer than 16 inches no further away than 30
inches from your eyes. The optimal distance is 25 inches.
※ Contact the sales outlet if you wish to purchase optional extras.
Actual components may look different from the pictures below.
2
Index
This device has passed the electromagnetic wave test and may be used in any
place including residential areas.
Prior to use
Connection & Installation
OSD(On Screen Display)screen select & control
Additional Information
Safety Precautions
Component Name & Introduction
FCC Information
Component Name & Introduction
Connecting the Monitor to a Camputer
Install the Monitor Driver
Adjusting the Monitor Screen
OSD adjusting
MISC
Recommendations
Self-Diagnosis Function
Troubleshooting
Product Specification
Supported mode table
Power Save Mode
4-6
7
1
8
9 - 10
7
17
18
19
20
21
21
11
12
13
14
15
16
※ Limited Warranty
※ Regulatory Information
3
Sound
Screen adjusting
Color adjusting
Provide sufficient space between the monitor and the
wall for ventilation (cooling).
Overheating may lead to fire.
Make sure that the ventilation holes are not covered by
fabrics, curlains, other clothes like material, etc.
Do not connect more than one plug
to a single wall outlet. Doing so may
lead to fire.
Do not bend the power cord
excessively or allow the cord to be
compressed under a heavy object.
Doing so may cause electric shock
or fire.
Insert the power plug securely into
the outlet.
Insecure and unstable electrical
contact may lead to fire.
Connect the power plug to grounded
power outlets only. Failure to do so
may cause electric shock or injury.
Do not pull the power cord when
unplugging the power, and do not
touch the power plug with wet
hands. Doing so may cause
electric shock or fire.
Do not use a danaged power
cord or plug, or connect to a loose
power outlet. Doing so may cause
electric shock or fire.
Cautions are categorized into two types, "Warning" and "Caution" depending on
their level of importance.
: May lead to accidents causing serious human injury
: May lead to minor accidents and damage
Ignoring the safety precautions may lead to accidents causing injury or fatality and
structural damage.
The contents of this section are intended to protect the user from danger and
prevent physical accidents. Please read through the contents for proper use.
Safety Precautions
4
5
Safety Precautions
Do not place candles, lighted cigarettes, or other
heat-radiating objects on the monitor or near the
monitor.
Doing so may lead to fire.
Place the monitor on a firm flat surface and be
careful when handling the monitor.
Disconnect the power when
cleaning the product.
Falure to do so may cause electric
shock or fire.
Set the PC to match the resolution and frequency of the monitor.
24" Types - 1920 X 1200 @ 60Hz
Do not use flammable sprays or
substances near the product.
Doing so may lead to explosion or
fire.
Do not place the product in a
place where the ventilation is poor
(eg. inside a cabinet).
Doing so may lead to fire.
Mishandling the product may cause short circuits
and damage the product or cause injury.
The contents of this section are intended to protect the user from danger and
prevent physical accidents. Please read the contents for proper use.
Safety Precautions
Set the PC to activate power save mode (DPMS) when the monitor is not used for a while. Set the
screen saver function and select a type that maintains motion in the whole screen.
Do not insert metallic objects into the
ventilation holes. They may cause
electric shock or fire.
Unplug the monitor when not using for a long period of
time.
Dust build-up on the product (near the vents) may
cause overheating and lead to fire. Use a dry soft cloth
for cleaning purposes.
Use a soft dry cloth to clean the monitor, and unplug
it before cleaning.
Do not use any chemical solutions on the monitor for
cleaning purposes. Do not use a wet cloth on the
monitor.
Do not install the monitor where water (rain) drops
can enter the enclosure, or where there is oil or
humidity.
It may cause electrical faults, fire, or lead to damage
to the monilor.
Clean any dirt, dust or water from the power
plug contacts.
They may cause electrical faults or fire.
Do not spray water directly onto the product.
It may cause electrical faults or fire.
Carefully unplug the monitor if you see any signs
of smoke or smell odor of burning.
Contact the manufacturer for further information.
Do not allow children to climb onto
the product or hang on it. The
product may fall over and cause
serious injury.
Do not attempt to dismantle, repair, or
modify the product yourself. This may
cause fire or electrical fail ures.
6
Loading...