B68A Wireless Gateway
Quick Start
96722598_01
1 Getting to know your B68A
Power button
WPS button
LAN port Connect to computer, switch, or other LAN device.
Power port Connect to compatible power adapter.
Telephone port Connect to telephone.
External antenna
port
Power indicator
Press and hold for about 3 seconds to power the
B68A on or off.
Press and hold for 3 or more seconds to active WPS
connection when Wi-Fi is turned on.
Connect to external antenna.
On: the B68A is powered on.
Off: the B68A is powered off.
1
Fast red blinking: no SIM/USIM card is found, the
PIN is not verified, or the SIM/USIM card is not
working properly.
Steady yellow: registered with a 3G/2G network.
Steady green: connected to the Internet.
Off: no signal.
Steady on: Wi-Fi turned on or data transfer in
progress.
Blinking: a WPS connection is being set up.
Off: Wi-Fi turned off.
Steady on: LAN port is connected to a client.
Blinking: data is being transmitted through LAN
port.
Off: no client is connected to LAN port.
Install a SIM/USIM card to access to the Internet via
a 3G/2G data connection.
Restoring the default settings of the B68A will erase
all previous settings.
Network mode
indicator
Wi-Fi/WPS
indicator
/ / /
LAN indicator
SIM/USIM card
slot
When the B68A is powered on, use a sharply
Reset button
pointed object to press and hold for about 3 seconds
until all indicators are blinking to restore the B68A to
its factory settings. After the factory defaults are
restored, the B68A will restart automatically.
2
2 Installation
Reset
Installing the SIM/USIM card
1. Slide off the card slot cover.
2. Insert the SIM/USIM card into the card slot. Ensure that the beveled edge of the
SIM/USIM card aligns with that of the card slot.
3. Close the card slot cover.
Before removing the SIM/USIM card, ensure that the B68A is powered off and
disconnected from the power outlet.
(Optional) Installing the table stand
The table stand is an optional accessory, and may not included in the packaging box.
If required, please contact your local dealer purchase it.
You can place the B68A on a flat surface such as a table or a desk, or hang it on a
wall. You can also use the table stand of the B68A to place it upright.
Insert the latches into the table stand slots on the bottom of the B68A.
3
(Optional) Installing the external antenna
The external antenna is an optional accessory, and may not included in the packaging
box. If required, please contact your local dealer purchase it.
Before installing the external antenna, ensure that the B68A is powered off and
disconnected from the power outlet.
Only use the external antenna indoors, and do not use it during thunderstorm.
Do not change another unexpected antenna unless manufacture provide.
In areas with poor reception, connect an external antenna to the B68A's external
antenna port to improve signal reception.
Before using external antenna, log in to the web management page (default address:
http://192.168.1.1, default password: admin). Choose Internet > Mobile
Network and set Antenna mode to Outer.
4
Loading...