
1 Getting to know your B315
Power indicator
Network mode
indicator
Wi-Fi/WPS
indicator
On: the B315 is powered on.
Off: the B315 is powered off.
Steady cyan: connected to an LTE network.
Steady green: connected to an Ethernet network.
Steady red:
– The SIM card is not recognized, the PIN has not
been entered, or the PIN verification failed.
– Failed to connect to a mobile network or an
Ethernet network.
Steady on: Wi-Fi turned on.
Blinking: a WPS connection is being set up.
Off: Wi-Fi turned off.
1

Steady on:
– At least one of the LAN ports is connected to a
device.
LAN/WAN
indicator
Signal strength
indicator
SIM card slot
External antenna
port
WPS button
Power button
– WAN port is connected to an Ethernet port.
Blinking: data is being transmitted through a LAN
port or the WAN port.
Off:
– No device is connected to a LAN port.
–
WAN port is not connected to an Ethernet port.
On: signal reception available (more bars mean
better reception).
Off: no reception.
Install a standard SIM card to access the Internet via
an LTE data connection.
Connect to external antenna after remove the cover.
Press and hold for 2 or more seconds until is
blinking to active WPS connection when Wi-Fi is
turned on.
Press and hold for about 3 seconds to power the
B315 on or off.
Restoring the default settings of the B315 will erase
all previous settings.
When the B315 is powered on, use a sharply
Reset button
pointed object to press and hold for about 3 seconds
until indicator is blinking to restore the B315 to
its factory settings. After the factory defaults are
restored, the B315 will restart automatically.
Power port Connect to compatible power adapter.
LAN port Connect to computer, switch, or other LAN device.
Working as a LAN port when connected to a
LAN4/WAN port
computer, switch, or other LAN device.
Working as a WAN port when connected to an
Ethernet port on the wall.
2

Connect to a USB storage device, or USB printer.
Do not remove the SIM card when it is in use. Doing so will affect the performance of
your B315 and data stored on the SIM card may be lost.
c
This port cannot be connected to USB host devices
such as computers.
The B315 supports USB 1.0/USB 2.0 storage devices
USB port
Telephone port Not in use.
in FAT32 format of up to 32 GB. Storage devices with
power supply requirements exceeding USB standards
may not work properly. It is recommended that you
prepare an external power supply in these cases.
The B315 is compatible with samba-supported USB
printers.
2 Installation
Scenario 1: Accessing the Internet using an LTE
network
Step 1: Installing the SIM card
1. Slide off the card slot cover.
2. Insert the SIM card into the card slot. Ensure that the beveled edge of the SIM card
aligns with that of the card slot.
3. Close the card slot cover.
ard memory, rendering it unusable.
3
This may damage the SIM

Step 2: Connecting cables
numbers that vary by region. For details about the specific adapter model, contact
To prevent interference caused by radio signals, place the B315 at least 1 meter
(3.28 feet) away from telephone and other electrical devices.
Use only the power adaptor supplied by the manufacturer for this device. The
B315's power adapter model is HW-120100XYW. X and Y represent letters or
an authorized dealer.
Once connected to a power outlet, the B315 automatically powers on.
Warning: This equipment may not work when mains power fails.
Power adapter
USB flash drive
4
Computer
Laptop, tablet, or smart
phone