Hp Moonshot User Manual

The information contained herein is subject to change without notice. The only

be construed as constituting an additional warranty. HP shall not be liable for

HP ProLiant Moonshot Server

Installation Instructions

Overview

Installation of a cartridge requires the following steps:

1. Install the drive on the new cartridge, if needed.

2. Install the cartridge in the chassis.

3. Power up the chassis, if needed.

For definitions of the acronyms used in this document, see the "Acronyms and abbreviations" in the cartridge user and maintenance guide.

Installing the drive

1. Extend the chassis from the rack.

2. Remove the access panel.

3. Remove the cartridge.

4. Remove any drive installed on the cartridge.

5. Install the drive as indicated.

warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should

technical or editorial errors or omissions contained herein.

Part Number: 711774-002 May 2013 Edition: 2

6. Install the cartridge.

7. Install the access panel.

For cartridge-specific information, see the cartridge user and maintenance guide on the HP Moonshot Information Library (http://www.hp.com/go/moonshot/docs).

Installing the cartridge

CAUTION: For proper cooling, be sure that a cartridge or a cartridge blank is always installed in each cartridge slot in the chassis. When replacing a cartridge, leave the cartridge slot empty for no more than 30 seconds. Failure to do so can disrupt airflow in the chassis.

IMPORTANT: After performing a procedure inside the chassis, always install the access panel on the chassis when complete. Do not operate the chassis for long periods of time with the access panel removed.

To install the component:

1. Extend the chassis from the rack.

2. Remove the access panel.