Microsoft, Windows, and Windows Vista are
either trademarks or registered trademarks
of Microsoft Corporation in the United States
and/or other countries.
All other product names mentioned herein
may be trademarks of their respective
companies.
Hewlett-Packard Company shall not be liable
for technical or editorial errors or omissions
contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material. The information in this document is
provided “as is” without warranty of any kind,
including, but not limited to, the implied
warranties of merchantability and fitness for
a particular purpose, and is subject to
change without notice. The warranties for
Hewlett-Packard products are set forth in the
express limited warranty statements
accompanying such products. Nothing
herein should be construed as constituting
an additional warranty.
This document contains proprietary
information that is protected by copyright. No
part of this document may be photocopied,
reproduced, or translated to another
language without the prior written consent of
Hewlett-Packard Company.
Fourth Edition (May 2008)
Document Part Number: 449162-004
About This Guide
This guide provides information on setting up the monitor, installing drivers, using the on-screen display
menu, troubleshooting and technical specifications.
WARNING!Text set off in this manner indicates that failure to follow directions could result in bodily
harm or loss of life.
CAUTION:Text set off in this manner indicates that failure to follow directions could result in damage
to equipment or loss of information.
NOTE:Text set off in this manner provides important supplemental information.
iii
iv About This Guide
Table of contents
1 Product Features
HP LCD Monitors ................................................................................................................................. 1
2 Safety and Maintenance Guidelines
Important Safety Information ................................................................................................................ 3
Disposal of Waste Equipment by Users in Private Household in the European
Union ................................................................................................................................. 53
vi
Restriction of Hazardous Substances (RoHS) ................................................................... 54
Appendix D LCD Monitor Quality and Pixel Policy
vii
viii
1Product Features
HP LCD Monitors
The flat panel monitors have an active matrix, thin-film transistor (TFT), liquid crystal display (LCD). The
monitor models and features include:
L1750 model, 43.2 cm (17-inch) diagonal viewable area display with 1280 × 1024 resolution, plus
●
full-screen support for lower resolutions
L1950 model, 48.3 cm (19-inch) diagonal viewable area display with 1280 x 1024 resolution, plus
●
full-screen support for lower resolutions
L1710 model, 43.2 cm (17-inch) diagonal viewable area display with 1280 × 1024 resolution, plus
●
full-screen support for lower resolutions
L1910 model, 48.3 cm (19-inch) diagonal viewable area display with 1280 × 1024 resolution, plus
●
full-screen support for lower resolutions
L1908w model, 48.3 cm (19-inch) diagonal viewable area display with 1440 × 900 resolution, plus
●
full-screen support for lower resolutions; includes custom scaling for maximum image size while
preserving original aspect ratio
L1908wm model, 48.3 cm (19-inch) diagonal viewable area display with 1440 × 900 resolution,
●
plus full-screen support for lower resolutions; includes custom scaling for maximum image size
while preserving original aspect ratio
L1945w model, 48.3 cm (19-inch) diagonal viewable area display with 1440 × 900 resolution, plus
●
full-screen support for lower resolutions; includes custom scaling for maximum image size while
preserving original aspect ratio
L1945wv model, 48.3 cm (19-inch) diagonal viewable area display with 1440 × 900 resolution, plus
●
full-screen support for lower resolutions; includes custom scaling for maximum image size while
preserving original aspect ratio
L2208w model, 55.88 cm (22-inch) diagonal viewable area display with 1680 x 1050 resolution,
●
plus full-screen support for lower resolutions; includes custom scaling for maximum image size
while preserving original aspect ratio
L2245w model, 55.88 cm (22-inch) diagonal viewable area display with 1680 x 1050 resolution,
●
plus full-screen support for lower resolutions; includes custom scaling for maximum image size
while preserving original aspect ratio
Wide viewing angle to allow viewing from a sitting or standing position, or moving side-to-side
●
Tilt capability
●
Pivot capability to rotate display to portrait mode (select models)
●
HP LCD Monitors1
Swivel and height adjustment capabilities (select models)
●
Removable base for flexible monitor panel mounting solutions
●
Video signal input to support VGA analog with VGA signal cable provided
●
Video signal input to support DVI digital with DVI-D signal cable provided (select models)
●
USB 2.0 hub with one upstream (connects to the computer) and two downstream (connects to USB
●
devices) ports (select models)
USB cable provided to connect the monitor's USB hub to the USB connector on the computer
●
(select models)
Accessory rail on monitor to accept optional mounted devices, such as an HP speaker bar
●
Plug and play capability if supported by the system
●
Privacy filter slots to insert filters (purchased separately) to block side screen viewing (select
●
models)
Security slot provision on rear of monitor for optional cable lock
●
Internal speakers (select models)
●
Audio input signal cable (select models)
●
Cable management feature for placement of cables and cords
●
On-Screen Display (OSD) adjustments in several languages for easy setup and screen
●
optimization
HP Display Assistant for adjusting monitor settings
●
Software and documentation CD that includes software, monitor drivers, and product
●
documentation
Energy saver feature to meet requirements for reduced power consumption
●
Intelligent Management AssetControl
●
Compliant with the following regulated specifications:
●
European Union CE Directives
◦
Swedish MPR II 1990
◦
Swedish TCO Requirements
◦
Energy Star
◦
2Chapter 1 Product Features
2Safety and Maintenance Guidelines
Important Safety Information
A power cord is included with the monitor. If another cord is used, use only a power source and
connection appropriate for this monitor. For information on the correct power cord set to use with the
monitor, refer to the
WARNING!To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding feature. The grounding plug is an important safety feature.
• Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.
• Disconnect power from the product by unplugging the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one may
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the electrical
outlet, grasp the cord by the plug.
Power Cord Set Requirements on page 52 in Appendix C.
To reduce the risk of serious injury, read the Safety and Comfort Guide. It describes proper workstation,
setup, posture, and health and work habits for computer users, and provides important electrical and
mechanical safety information. This guide is located on the Web at
the documentation CD, if one is included with the monitor.
CAUTION: For the protection of the monitor, as well as the computer, connect all power cords for the
computer and its peripheral devices (such as a monitor, printer, scanner) to some form of surge
protection device such as a power strip or Uninterruptible Power Supply (UPS). Not all power strips
provide surge protection; the power strips must be specifically labeled as having this ability. Use a power
strip whose manufacturer offers a Damage Replacement Policy so you can replace the equipment, if
surge protection fails.
http://www.hp.com/ergo and/or on
Important Safety Information3
Maintenance Guidelines
To enhance the performance and extend the life of the monitor:
Do not open the monitor cabinet or attempt to service this product yourself. Adjust only those
●
controls that are covered in the operating instructions. If the monitor is not operating properly or
has been dropped or damaged, contact an authorized HP dealer, reseller, or service provider.
Use only a power source and connection appropriate for this monitor, as indicated on the label/
●
back plate of the monitor.
Be sure the total ampere rating of the products connected to the outlet does not exceed the current
●
rating of the electrical outlet, and the total ampere rating of the products connected to the cord does
not exceed the rating of the cord. Look on the power label to determine the ampere rating (AMPS
or A) for each device.
Install the monitor near an outlet that you can easily reach. Disconnect the monitor by grasping the
●
plug firmly and pulling it from the outlet. Never disconnect the monitor by pulling the cord.
Turn the monitor off when not in use. You can substantially increase the life expectancy of the
●
monitor by using a screen saver program and turning off the monitor when not in use.
Slots and openings in the cabinet are provided for ventilation. These openings must not be blocked
●
or covered. Never push objects of any kind into cabinet slots or other openings.
Do not drop the monitor or place it on an unstable surface.
●
Do not allow anything to rest on the power cord. Do not walk on the cord.
●
Keep the monitor in a well-ventilated area, away from excessive light, heat or moisture.
●
When removing the monitor base, you must lay the monitor face down on a soft area to prevent it
●
from getting scratched, defaced, or broken.
Cleaning the Monitor
1.Turn off the monitor and the computer.
2.Unplug the monitor from the wall outlet.
3.Clean the monitor plastics with a clean cloth dampened with water.
4.Clean the monitor screen with an antistatic screen cleaner.
CAUTION:Do not use benzene, thinner, ammonia, or any other volatile substances to clean the
monitor or the screen. These chemicals may damage the cabinet finish as well as the screen.
Shipping the Monitor
Keep the original packing box in a storage area. You may need it later if you move or ship the monitor.
4Chapter 2 Safety and Maintenance Guidelines
3Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
Unfolding the Double-Hinged Monitor Pedestal Base
1.Lift the monitor from its box and place it on a flat surface with the display head facing up.
2.Pivot the display head from portrait to landscape position (1).
3.Remove the swivel locking pin (2).
Figure 3-1 Removing the Swivel Locking Pin
Unfolding the Double-Hinged Monitor Pedestal Base5
4.Using both hands on the outer edges of the display bezel, pull up gently on the monitor display
head (1) to extend the pedestal base (2) to the desired height.
CAUTION:Do not touch the surface of the LCD panel. Pressure on the panel may cause non-
uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover
to its normal condition.
Figure 3-2 Unfolding the Monitor Pedestal Base
6Chapter 3 Setting Up the Monitor
Unfolding the Single-Hinged Monitor Pedestal Base
1.Lift the monitor from its box and place it face down on a flat surface covered by a soft, clean cloth.
2.Hold down the monitor display head with one hand and unfold the base 90 degrees with the other
hand.
CAUTION:Do not touch the surface of the LCD panel. Pressure on the panel may cause non-
uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its
normal condition.
Figure 3-3 Unfolding the Monitor Pedestal Base
Unfolding the Single-Hinged Monitor Pedestal Base7
Rear Components
Figure 3-4 Rear Components
ComponentFunction
1AC Power ConnectorConnects the AC power cord to the monitor.
2Audio In (select models)Connects the audio cable to the monitor's internal speakers
(select models)
3USB Downstream
Connectors (2) (select
models)
4USB Upstream
Connector (select
models)
5DVI (select models)Connects the DVI-D cable to the monitor.
6VGAConnects the VGA cable to the monitor.
Connects optional USB devices to the monitor.
Connects the USB hub cable to the monitor's USB hub
connector and to a host USB port/hub.
8Chapter 3 Setting Up the Monitor
Cable Management
Use the cable management feature to secure and hide your cables when viewed from the front.
Before connecting the cables to monitor models with a single-hinged base, route the cables through the
hole in the center of the monitor stand.
Figure 3-5 Using the Cable Management Feature (Single-Hinged Base)
After connecting the cables to monitor models with a double-hinged base, place the cables through the
cable management channels on the sides of the monitor base.
Figure 3-6 Using the Cable Management Feature (Double-Hinged Base)
Cable Management9
Connecting the Cables
1.Place the monitor in a convenient, well-ventilated location near the computer.
2.Connect a VGA signal cable or DVI-D signal cable.
NOTE:For models with both VGA and DVI-D connectors, the monitor is capable of supporting
either analog or digital input. The video mode is determined by the video cable used. The monitor
will automatically determine which inputs have valid video signals. The inputs can be selected by
pressing the +/Input button on the front panel or through the On-Screen Display (OSD) feature by
pressing the Menu button.
For analog operation, use the VGA signal cable provided. Connect the VGA signal cable to
●
the VGA connector on the rear of the monitor and the other end to the VGA connector on the
computer.
For digital operation, use the DVI-D signal cable provided (select models). Connect the DVI-
●
D signal cable to the DVI connector on the rear of the monitor and the other end to the DVI
connector on the computer.
Figure 3-7 Connecting the Signal Cable
3.Connect the built-in monitor speakers (on select models) to the computer using the audio cable.
10Chapter 3 Setting Up the Monitor
4.Connect one end of the provided USB cable to the USB hub connector on the rear panel of the
computer, and the other end to the upstream USB connector on the monitor (on select models).
Figure 3-8 Connecting the USB Cable
WARNING!To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no one may
accidentally step on or trip over them. Do not pull on a cord or cable. When unplugging from the
electrical outlet, grasp the cord by the plug.
Connecting the Cables11
Loading...
+ 44 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.