HP FT-PRS Lexmark Optra T-SE

Installing the FT-PRS onto LexmarkTM Optra-T/SETM Toner Cartridges

1. The LexmarkTM OptraTM-T/SE is

2. By lifting the back of the cartridge,

3. Once the 2 hooks of the spring

4. Remove adhesive backing from

5. Position the FT-PRS where the

metal plate once was so that the 2 metal contacts on the FT-PRS are near the back of the cartridge as is

6. Now press down on each side of on the underside is securely

7. Once completed the FT-PRS

about.

8. The Dallas DS 1982 can be removed and sent to your distributor

9. Simply install the toner cartridge

factory fitted with a DallasTM DS1982 EPROM secure memory located on top of the cartridge as indicated by the white arrow.

the solder-side of the FT-PRS – Do not remove the tape itself. A sharp edged tool will make removal easier.

use a flat bit tool to flatten the spring metal hooks at the back of the cartridge. Move the handle in direction of the white arrow.

seen by the illustration.

metal plate have been flattened, use your thumb to move the plate forward. This forward motion will free the metal plate positioning the DallasTM DS1982 EPROM.

the FT-PRS so that the tape located attached and will not fall off again.

positioned on the cartridge will resemble the diagram above. There are no wires, power connections or encoder wheels to be concerned

T/SE/K lockout over-ride

for resetting if required.

LexmarkTM Optra

technology

back into the printer and it will function without further intervention.