Hotpoint MW 222.1 K Instruction booklet

Instructions for use

MICROWAVE OVEN

English, 1

MW 222.1 KX

Contents

Installation, 2-4

Installation Placement Building in Install the grill pan Turntable Installation

Setting up your oven, 5-6

Overall view Names of Oven Parts and Accessories Control Panel and Features

Start-up and use, 7-9

Operation instruction

Important safety instructions, 10-11

Utensils, 12

Utensil Test Materials you can use in microwave oven Materials to be avoided in microwave oven

Maintenance and care, 13

Cleaning

Troubleshooting, 14

Assistance, 15

Guarantee, 16

After Sales Service, 17

Installation

! Read these instructions carefully before using your microwave oven, and keep it carefully. If you follow the instructions, your oven will provide you with many years of good service.

! SAVE THESE INSTRUCTIONS CAREFULLY

PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY.

a) Do not attempt to operate this oven with the door

open since this can result in harmful exposure to microwave energy. It is important not to break or tamper with the safety interlocks.

b) Do not place any object between the oven front

face and the door or allow soil or cleaner residue to accumulate on sealing surfaces.

c) WARNING: If the door or door seals are damaged, the

oven must not be operated until it has been repaired by a competent person.

ADDENDUM

If the apparatus is not maintained in a good state of cleanliness, its surface could be degraded and affect the lifespan of the apparatus and lead to a dangerous situation.

Please Read the Manual Carefully Before Installation

Please note

Electrical connection

The oven is fitted with a plug and must only be connected to a properly installed earthed socket. The socket must only be installed and the connecting cable must only be replaced by a qualified electrician, and in accordance with the appropriate regulations. If the plug is no longer accessible following installation, an all-pole isolating switch must be present on the installation side with a contact gap of at least 3 mm. The fitted cabinet must not have a back wall behind the appliance. Minimum installation height: 85 cm. Do not cover ventilation slots and suction holes.

Note:

Do not trap or bend the power cable.

A. Built-in furniture

Installation and Connection

1. This appliance is only intended for domestic use.

2. This oven is intended for built-in use only.It is not intended for counter-top use or for use inside a cupboard.

3. Please observe the special installation instructions.

4. The appliance can be installed in a 60cm wide wallmounted cupboard(at lease 55cm deep and 85cm off the floor).

5. The appliance is fitted with a plug and must only be connected to a properly installed earthed socket.

6. The mains voltage must correspond to the voltage specified on the rating plate.

7. The socket must be installed and connecting cable must only be replaced by a qualified electrician.If the plug is no longer to accessible following installation,an all-pole disconnecting device must be present on the installation side with a contact gap of at lease 3mm.

8. Adapters,multi-way strips and extension leads must not be used. Overloading can result in a risk of fire.

The accessible surface may be hot during operation.

380+2

B.Prepare the cabinet

1. Read the instruction on the BOTTOM CABINET TEMPLATE, put the template on the bottom plane of cabinet.

LEFT EDGE

CENTER LINE

FRONT EDGE

2. Make the marks on the bottom plane of cabinet according to marks ”a” of of the template.

Screw A

RIGH

T EDGE

Bracket

Centre line

3. Remove the bottom cabinet template and fix the bracket with screw A.

Screw A

Bracket

C .Install the oven

4. Install the oven to the cabinet

- Make sure the back of the oven is locked by bracket.

- Do not trap or kink the power cord.

Bracket

5. Open the door, fix the oven to the cabinet with Screw B, at the installation hole. Then fix the Trim-kit plastic cover to the installation hole.

Screw B

Installation Hole

5RGEKſECVKQPU

Model:

Rated Voltage: 2 0V~50Hz 4

Rated Input Power (Microwave):

Rated Output Power (Microwave):

Rated Input Power (Grill):

Oven Capacity: 25L

Turntable Diameter: ø 315mm

External Dimensions: 595x400x388mm

Net Weight: Approx. 18.7 kg

MW 222.1 KX

1450W

900W

1000W

According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should be separately collected and treated. If at any time in future you need to dispose of this product please do NOT dispose of this product with household

Setting up your oven

Overall view

Names of Oven Parts and Accessories

Remove the oven and all materials from the carton and oven cavity. Your oven comes with the following accessories:

Glass tray 1

Turntable ring assembly 1

Instruction Manual 1

Sucker 1

A) Control panel

B) Turntable shaft

C) Turntable ring assembly

D) Glass tray

E) Observation window

F) Door assembly

G) Safety interlock system

H) Door opening button

Grill Rack( Only be used in grill function and be placed on the glass tray )

Sucker

Note:When power cord unplug or oven door error,it is hard to open the door.You can use the sucker to open the door.

Turntable Installation

Hub (underside)

Glass tray

Turntable shaft

a. Never place the glass tray upside down. The glass

tray should never be restricted.

b. Both glass tray and turntable ring assembly must

always be used during cooking.

c. All food and containers of food are always placed on

the glass tray for cooking.

d. If glass tray or turntable ring assembly cracks or

breaks, contact your nearest authorized service center.

Turntable ring assembly

+ 14 hidden pages