Hoover HFPB1V1, HFPB2V1 User Manual

Version 1.0

Floor
Polisher

User Guide

HFPB1V1
HFPB2V1
Hoover.ae
Hoover.za.com

MACHINE OVERVIEW

GENERAL SAFETY INFORMATION

Unit

1

7

4

2

8

5

3

6

1

2

Accessories

7

Handle assembly upper section
Handle assembly lower section
Handle height adjust
Cleaning and polishing head
Scrubbing pads (white) x2
Coral cleaning/polishing
pads (blue) x2
Scrubbing brush plates x2
Velcro backing plates for scrubbing
and polishing pads x2

3

FOR HOUSEHOLD USE ONLY. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.

When using the Hard Floor Polisher, basic safety precautions should always be observed, including
the following:

1. Do not leave the Hard Floor Polisher to run unattended for any period of time.

2. Do not use outdoors.

3. Do not use on carpet.

4. Children should be supervised to ensure that they do not play with the appliance.

5. This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance.

6. Cleaning and user maintenance shall not be made by children without supervision.

7. Do not use with a damaged cord. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

8. The appliance should only be used as described in this user guide.

9. Only Hoover recommended attachments should be used with this appliance.

10. Do not pull or carry the unit by the cord, use the cord as a handle, allow the cord to come into
contact with hot or sharp surfaces or close a door on the cord.

11. Do not unplug by pulling on the cord.

12. Do not pull or carry this appliance by the cord. Do not use the cord as a handle, close a door on
the cord or pull the cord around sharp edges or corners. Do not run the Hard Floor Polisher over
the cord. Keep the cord away from heated surfaces.

13. Do not handle the plug or Hard Floor Polisher with wet hands.

14. Do not put any objects into openings or operate with openings blocked, keep them free of
anything that may impair operation.

15. Keep hair, loose clothing, fingers and all parts of the body away from openings and moving parts.

16. Do not use the Hard Floor Polisher on any glowing, burning or smoking particles.

17. Store in a dry place. Do not expose machine to freezing temperatures.

18. Do not use to pick up flammable or combustible liquids such as petrol, or use in areas where they
may be present.

19. Keep the unit on the floor.

20. Do not attempt to remove blockages with sharp objects as they may cause damage.

21. Store indoors put away after use to prevent tripping accidents.

22. Using improper voltage may result in damage to the motor and possible injury to the user.
The correct voltage is listed on the rating label.

23. Do not carry appliance while motor is running.

24. Do not immerse power cable, plug or machine in water or any other liquid.

25. Do not use this Hard Floor Polisher if it has been dropped, damaged, left outdoors or dropped
into water.

26. Check pads for embedded grit or hard material before using on floors or scratching may occur.

This Hard Floor Polisher is intended for household use only and NOT for commercial or industrial use.

PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.

2

1

4

5

6

8

Warning: Always switch off and unplug the Hard Floor Polisher from the electrical socket before
assembling, opening or emptying the bin, or before connecting/disconnecting the attachments.

OPERATION

OPERATION

4

Assembling your Floor Polisher

3

Insert the lower section of the handle into the
aperture at the top of the head and screw the
collar in securely.

Changing the pads and plates on your product

Invert the cleaning
head so that the drive
hubs are accessible.

Place the required
hook and loop
backing plate
(for pads) or brush
plate over the hub,
making sure the four
connectors are aligned
to the holes in the hub.
Press the plate down
to clip into place.

Simply pull the
plates/brushes off to
remove and change.

Coral and scrubbing
pads can be applied
directly to the velcro
backing plates and
peeled off to remove.

Important: Always use two plates/pads of the same type.

Adjust the height of
the handle to suit your
needs by pulling on the
extension button.

Adjusting the handle

For additional stability the pro-grip handle can
be opened to enable two-handed use.

Important: Please test Hoover Floor Polisher on a small area of flooring before use, please do not
continue use if any damage is caused during the test.

Turning on and off

Insert power plug
into mains socket.
Place your foot on
the base and pull the
handle back to turn on.
To switch off, return
the handle to upright
position and fix
into place.

Push the plastic upper
handle section until
the metal button clicks
into place. Ensure the
handle is attached
securely prior to using.