Hoover HFFBP 3050K Instruction Manual

BUILT-IN FRIDGE-FREEZER AND BUILT-IN FROST FREE FRIDGE-FREEZER

EN

REVERSING THE OPENING OF THE DOORS

2 EN

Remove the pin and the corresponding
bush of the top crossbar.

Remove the top door.

Remove the central hinge and the
corresponding washers.

Remove the bot tom door.

Remove the pin of the bottom right-hand
hinge and remount it on the bottom left­hand hinge.

Invert the plate cover of the cabinet
mounted on the plate.

Reassemble the hinges and doors working
from bottom to top 1 2 3.

BUILT-IN FRIDGE-FREEZER AND BUILT-IN FROST FREE FRIDGE-FREEZER

CONTROL PANEL

FREEZING OF THE FREEZER COMPARTMENT

DEFROSTING OF THE FREEZER COMPARTMENT

The thermostat box to control the appliance is located inside the fridge compartment
on the top right. To check whether the appliance is functioning, make sure that the
thermostat knob is not set on "0“. Adjust the knob according to the desired temperature
in the fridge.

In this product the freezer compartment is automatically defrosted.
A small amount of frost or drops of water on the back of the fridge compartment when
the fridge is working is normal.

Make sure the water outlet is always clean. Make sure foods do not touch the back or
sides of the fridge compartment

Important: If the room temperature is very warm, the appliance may work
continuously and a layer of frost will deposit on the back of the fridge
compartment. In this case, turn the knob to lower settings.

Place the foods to be frozen in the drawer. At the start of the freezing process, so as not to make the fridge compartment excessively cold, it may
be necessary to turn the thermostat knob back, according to the load and room temperature. Once the freezing process is completed, return the
thermostat knob to the usual value. The rating plate states the maximum quantity of foods that can be frozen, (see fi gure 2).

In case of a fridge with FROST FREE technology, the freezer compartment does not need to be defrosted
because this product is equipped with an automatic system which prevents ice from forming;

In case of a version without FROST FREE technology, it is recommended to manually defrost the
product when the layer of frost is more than 3 mm thick, by setting the knob on "0". Open the door and
remove the foodstuffs, making sure to store them in a cool place. Leave the door open as long as is
necessary for the layer of frost to melt. Dry the inside of the freezer with a sponge/cloth. Reposition the
foodstuffs and reset the knob to the usual values.

N.B.: This is the rating plate. If you need to contact our Service Department in the event of faults,
remember to give them the information on the plate.

N.B.: For better air circulation, leave some room between the foodstuffs.
In case of models with FROST FREE technology, avoid obstructing the
cooling air vents.

N.B.: To TEST consumption and preservation standards,
remove all drawers except for the bottom one.

(fi gure 1)

(fi gure 2)