Honeywell V5822A, V5823A, V5823C DATASHEET

V5822A/5823A,C

SMALL LINEAR VALVES PN16

FOR MODULATING AND ON/OFF-CONTROL

SPECIFICATION DATA

V5822A V5823A

V5823C

GENERAL

These small linear valves are used in combination with small
electric linear valve actuators and thermoelectric actuators for
the control of hot and/or chilled water for fan coil units and
small reheaters/recoolers in electric/electronic temperature
control systems.

FEATURES

• Small size allows installation where space is limited

• Range of fittings available for different connections

(compression, soldered, threaded)

• Long stroke results in a high-quality characteristic

• Soft seat provides low leakage rate and high

rangeability

• Reduced k

hydronic balancing

• Adjustment cap for manual operation

• Valve inserts changeable without draining by using

insert replacement tool WV 108

• Compatible with two-piece conex compression

fittings

• Conical sealing connections

• Flat surfaces on body to fit installation tools

• 40 mm distance between ports A/AB and the bypass

(V5823C, only)

values in the bypass to facilitate

VS

SPECIFICATIONS

Models Two-way V5822A
Three-way V5823A
Three-way with bypass V5823C

Operation Two-way stem up to open,
port A to B; Three-way stem up
to close, port A to AB

Nominal pressure rating PN16

Capacity index (k

Leakage rate ≤0.02% of k

Valve body
Material Brass
Size DN15 (1/2“), DN20 (3/4“)

) see tables on page 2 and 3

VS

VS

Trim
Stem Stainless steel
Plug Brass

Suitable medium Water, with max. 50% glycol

Controlled water
temperature 2...120 °C

® U.S. Registered Trademark EN0B-0307GE51 R0209
Copyright © 2009 Honeywell Inc. • All rights reserved

V5822A/V5823A,C SMALL LINEAR VALVES PN16

Modulating valves
Rangeability
Two-way valves 100:1
Three-way valves 100:1 for controlled port

Flow characteristic Equal percentage port A-AB,
n
linear for bypass port B-AB
Stroke 6.5 mm

On/Off valves
Stroke 2.5 mm

Dimensions see Fig. 4 on page 5

=3.4,

gl

FLOW CAPACITIES AND CLOSE OFF PRESSURE RATINGS

TWO-WAY VALVES

Valve Close-Off Pressure (kPa) with Actuators

DN kVS Order Number M6410C,L/M7410C,E

(180 N)

15 0.16 V5822A1006 1600 600 ­15 0.25 V5822A1014 1600 600 ­15 0.40 V5822A1022 1600 600 ­15 0.63 V5822A1030 1600 600 ­15 1.00 V5822A1048 1200 180 ­15 1.60 V5822A1055 1200 180 ­20 2.50 V5822A1063 400 50* ­20 4.00 V5822A1071 400 50* -
15 1.60 V5822A4000** 1200 180 180
20 2.50 V5822A4018** 400 50* 50*

*Up to 1000kPa system pressure. **In the case of on/off control, the stroke amounts to 2.5 mm.

THREE-WAY VALVES

Valve Close-Off Pressure (kPa) with Actuators

DN kVS Order Number M6410C,L/M7410C,E

(180 N)

15 0.25 V5823A2003 800 500 ­15 0.40 V5823A2011 800 500 ­15 0.63 V5823A2029 800 500 ­15 1.00 V5823A2037 250 150 ­15 1.60 V5823A2045 250 150 ­20 2.50 V5823A2151 240 - ­20 2.50 V5823A2052 100 50 ­20 4.00 V5823A2169 240 - ­20 4.00 V5823A2060 100 50 ­15 1.60 V5823A4009* 250 150 150
20 2.50 V5823A4017* 100 50 50

*In the case of on/off control, the stroke amounts to 2.5 mm.

M4450/M8450

(90 N)

M4450/M8450

(90 N)

Z100/M7410A

(90 N)

Z100/M7410A

(90 N)

EN0B-0307GE51 R0209 2

V5822A/V5823A,C SMALL LINEAR VALVES PN16

V

V

A

THREE-WAY VALVES WITH BYPASS

Valve Close-Off Pressure (kPa) with Actuators

k

DN

k

S

A-AB B-AB

S

Order Number

M6410C,L/M7410C,E

(180 N) (90 N) (90 N)

M4450/M8450 Z100/M7410

15 0.25 0.16 V5823C2009 800 500 ­15 0.40 0.25 V5823C2017 800 500 ­15 0.63 0.40 V5823C2025 800 500 ­15 1.00 0.63 V5823C2033 250 150 ­15 1.60 1.00 V5823C2041 250 150 ­20 2.50 1.60 V5823C2058 100 50 ­20 2.50 1.60 V5823C2157 240 - ­20 4.00 2.50 V5823C2066 100 50 ­20 4.00 2.50 V5823C2165 240 - ­15 1.60 1.60 V5823C4005* 250 150 150
20 2.50 2.50 V5823C4013* 100 50 50

*In the case of on/off control, the stroke amounts to 2.5 mm.

OPERATION

A built-in return spring in the two-way valve produces an
opening force. In the three-way valve and the three-way valve
with bypass, the spring produces a closing force on the A to
AB ports.

The valves are supplied with a screwed-on adjustment cap for
manual operation and for protection of the stem. This allows
the stem to be set up for filling or initial heating/cooling during
the building construction phase without the use of a controller
or actuator.

The small electric valve actuators as well as the
thermoelectric actuators provide automatic control over the
opening and closing movement of the valve stem.

TYPICAL OPERATION

All types of valves should be mounted in the return flow. If the
∆p-values exceed 60 kPa, attention should be paid to the
development of noise.

Two-Way Valves

Direction of flow always from port A to port B
Port B: Outlet

outlet

inlet

+

-

outlet

Fig. 1. Two-way valve operation

inlet

+

-

Three-Way Valves

These valves are preferably used as mixing valves, this
means:

Port AB: Total flow outlet
Port A: Controlled flow inlet
Port B: Bypass inlet

inlet

AB A

B

+

-

inlet

AB A

B

Fig. 2. Three-way valve operation

Three-Way Valves with Bypass

These valves simplify the installation, which is depending on
the layout of the pipework, as the bypass pipe is part of the
valve. The information for the normal three-way valves is also
valid for this type.

inlet

+

AB A

B

-

Fig. 3. Three-way valve with bypass

inlet

AB A

B

+

-

+

-

3 EN0B-0307GE51 R0209

V5822A/V5823A,C SMALL LINEAR VALVES PN16

MOUNTING

When installing the valve care must be taken that the flow
direction is correct (see section "Typical Operation"). The
valve must not be mounted with the stem pointing downward.
The adjustment cap must be removed from the valve only
when the actuator is fitted. The valve should be installed as
stress-free as possible with a tightening torque of 25 to
30 Nm.
The valve is supplied complete with mounting instructions.
The water quality must meet VDI 2035 requirements.

ACCESSORIES

For valves V5822A, two connection sets are necessary; for valves V5823A, three connection sets are necessary; for valves
V5823C, four connection sets are necessary.

Connection Pipe Size DN Order Number Connection Set Description

Compression

Soldering

External

Thread

Compression

(Conex)

*Cannot be purchased from Honeywell

15 mm
22 mm

12 mm
15 mm

R3/8"
R1/2"

15 mm
22 mm

15
20

15
20

15
20

15
20

ACN-15C
ACN-20C

ACN-15S
ACN-20S

ACN-15T
ACN-20T

63*
65*

Consisting of 1 union nut
and 1 ferrule

Consisting of 1 union nut
and 1 solder bush

Consisting of 1 union nut
and 1 tailpiece

Capnut and compression ring

Dimensions of Connection Sets

a b c d

G1/2“

11/8“ x 14 BS 84

G1/2“

11/8“ x 14 BS 84

G1/2“

11/8“ x 14 BS 84

15 mm

22 mm

R3/8"

ACN-15C

12mm

15mm

R1/2"

Order Number

ACN-20C

ACN-15S

ACN-20S

ACN-15T

ACN-20T

EN0B-0307GE51 R0209 4

DIMENSIONS

A

A

A

A

A

*

Two-way valve

Three-way valve

6.
5
Str
ok

18

6.5 Stroke* 6.5 Stroke* 6.5 Stroke*

*

6.
5
Str
ok

18

e*

M30x1.5

M30x1.5

llow 130mm for
the actuator and
clearance for
removal

llow 130mm for
the actuator and
clearance for
removal

V5822A/V5823A,C SMALL LINEAR VALVES PN16

DN15 56 G1/2A 34

DN20 66 11/8“x14BS 84 33

DN15 56 G1/2A 24.5 34

DN20 66 11/8“x14BS 84 33 33

a b d

b d

DN15 56 G 1/2A 34
DN20 6 11/8" x 14 BS 84

a b c d

a b d

DN15 56 G1/2
DN20 66 11/8" x 14 BS 84

33

34

33

c

a

Three-way valve with bypass

6.
5
Str
ok

*

18

M30x1.5

llow 130mm for
the actuator and
clearance for
removal

Modulating valves, only (in the case
of on/off valves, the stroke amounts
to 2.5 mm and the closure distance
to 14 mm).

DN15 56 G1/2

DN15 56 G1/2A 40 34

DN20 66 11/8" x 14 BS 84 40

DN20 66 11/8“x14BS 84 40 33

a b c d

a b c d

40 34

33

Fig. 4. Dimensions V5822A/V5823A,C in mm

5 EN0B-0307GE51 R0209

V5822A/V5823A,C SMALL LINEAR VALVES PN16

SPARE PARTS

Valve inserts are provided as spare parts for the V5822A and V5823A,C small linear valves. When the tool WV 108 is used, the
valve inserts can be changed without draining the system.

Order Number DN kVS

V5822A1006 15 0.16 0902812
V5822A1014 15 0.25 0902811
V5822A1022 15 0.40 0902810
V5822A1030 15 0.63 0902809
V5822A1048 15 1.00 0902808
V5822A1055 15 1.60 0902807
V5822A1063 20 2.50 0902814

V5822A1071 20 4.00 0902815
V5822A4000* 15 1.60 0902813
V5822A4018* 20 2.50 0902816

* For on/off control

Order Number DN kVS

V5823A2003 / V5823C2009 15 0.25 0902821
V5823A2014 / V5823C2017 15 0.40 0902822
V5823A2029 / V5823C2025 15 0.63 0902823
V5823A2037 / V5823C2033 15 1.00 0902824
V5823A2045 / V5823C2041 15 1.60 0902825
V5823A2151 / V5823C2058 20 2.50 0902826
V5823A2052 / V5823C2157 20 2.50 0902818
V5823A2169 / V5823C2066 20 4.00 0902827

V5823A2060 / V5823C2165 20 4.00 0902819
V5823A4009* / V5823C4005* 15 1.60 0902817
V5823A4017* / V5823C4013* 20 2.50 0902820

* For on/off control

Order Number

Valve Insert

Order Number

Valve Insert

The following valve inserts are interchangeable

• Two-way valves: k
k
k

• Three-way valves: k
k

Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sàrl, Rolle, Z.A. La Pièce 16, Switzerland by its Authorized Representative:

Automation and Control Solutions

Honeywell GmbH
Böblinger Strasse 17
71101 Schönaich
Germany
Phone: [phone]
Fax: [phone]
http://ecc.emea.honeywell.com
Subject to change without notice. Printed in Germany

EN0B-0307GE51 R0209

0.16, 0.25, 0.40, and 0.63

VS

1.0 and 1.6

VS

2.5 and 4.0

VS

0.25, 0.40, 0.63, and 1.0

VS

2.5 and 4.0

VS