Honeywell JTQJ-BF-01LM/BW User Manual

Setup instructions

1. Connection terminal, output signal and device connection

Honeywell GAS DETECTOR

Overview

The autonomous gas sensor (hereinafter referred to as the sensor) is a home
device for detecting a leak of natural gas (the main component is methane),
which, in the case of determining a high concentration of combustible gas
(methane) in the room, produces a light-sound alarm or sends a warning message
to the connected device.

Accessories

Alarm x1
Mounting plate x1
Battery x1

Holes for sound

The instruction x1
Plug dowel x2
Screw x2
Double-sided adhesive tape x2

* Even if the connection terminal is not connected to the device, the sensor will still
function.
* If you need to connect an electromagnetic solenoid valve or an output fan to the
wiring, please ask your dealer for assistance.

Сonnection terminal

«Sound/Self control» button

Holes for detecting a gas

Installation

1. Fastening with screws
a) Insert the battery into the battery compartment, press and hold the «Sound /
Self-check» button for 1 second. Make sure that the red-yellow indicator starts

ashing on the device, after which you will hear a corresponding beep.

b) Drill holes in the ceiling with a perforator;
c) Insert the dowels;
d) Using self-tapping screws, attach the mounting plate;
e) Attach the main alarm panel to the mounting panel in accordance with all the
index marks, go clockwise until you hear a characteristic click that indicates the

xation of the device.

Using self-tapping screws, install the mounting plate.
Attach the main alarm panel to the mounting panel in accordance with all the
indicia.
Turn clockwise until it clicks.

2. Mounting with adhesive tape
a) Insert the battery into the battery compartment, press and hold the «Sound /
Self-check» button for 1 second. Make sure that the red-yellow indicator starts

ashing on the device, after which you will hear a corresponding sound signal
b) Remove the protective lm from one side of the adhesive tape and attach it to

the back of the mounting panel;

c) Remove the protective lm from the other side of the adhesive tape and attach

the mounting plate to the ceiling;
d) Attach the main alarm panel to the mounting panel in accordance with all the
reference marks, go clockwise until you hear a characteristic click that indicates

the xation of the device.

Precautions for installation

a. Install the device in the premises where the gas (methane) is conducted;
b. Avoid places outside the premises;
c. Avoid rooms with a temperature below -10 ° C or above 55 ° C;
d. Avoid places near other devices, that produce hot air, water vapor or soot (for
example, directly above the gas stove);
e. There should be no barrier between the sensor and the gas equipment,
otherwise the sensor will not be able to measure the gas concentration level;
f. Avoid places at the hood, windows, entrance doors and other well-ventilated
places, otherwise the sensor will not have contact with the gas and will not be
able to measure its concentration level;
g. Make sure all sockets are plugged in;
h. It is recommended to perform the installation with screws, in the case of
installation with adhesive tape, unforeseen situations may occur, the user is
responsible for;
i. If installed with adhesive tape, make sure that the selected surface for attaching
the device is smooth, smooth, clean and dry;
j. If installed with adhesive tape, it is necessary to regularly check the reliability of
the fastening to prevent the sensor from falling.