When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If
provided, use handle when moving this heater.
Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains
at least 3 feet (0.9 m) from the front of the
heater and keep them away from the sides and
rear.
3. Extreme caution is necessary when any heater
is used by or near children or invalids and
whenever the heater is left operating and
unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged
cord or plug or after the heater malfunctions,
has been dropped or damaged in any manner.
Return heater to authorized service facility for
examination, electrical or mechanical
adjustment, or repair.
6. Do not use outdoors.
7. This heater is rated at 1500W, 120 VAC. It is
NOT intended for use on tabletops or
desktops, use
be used in wet or moist locations, such as
bathrooms and laundry areas. If an extension
cord must be used, it must be 14 gauge or
larger and rated no less than 1875 watts.
8. Do not run cord under carpeting. Do not cover
cord with throw rugs, runners, or the like.
Arrange cord away from traffic area where it
will not be tripped over
9. This appliance has a polarized plug (one blade
is wider than the other). To reduce the risk of
The Honeywell trademark is used by Kaz, Inc. under license from Honeywell Intellectual Properties, Inc.
ONLY ON FLOORS. It is not to
.
shock, this plug is intended to fit only one way
in a polarized outlet. If the plug does not fit
securely in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
attempt to defeat this safety feature.
NOT
10. This heater draws 12.5 amps during operation
when in the high setting. To prevent
overloading a circuit, do not plug the heater
into a circuit that already has other appliances
working.
11. It is normal for the plug to feel warm to the
touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause
overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn
outlet.
12. To disconnect the heater, first turn controls to
the
OFF position, then grip the plug and pull it
from the wall outlet. Never pull by the cord.
13. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the
heater.
14. To prevent a possible fire, do not block air
intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where openings
may become blocked.
15. A heater has hot and arcing or sparking parts
inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used
or stored.
16. Use this heater only as described in this
manual. Any other use not recommended by
the manufacturer may cause fire, electric
shock, or injury to persons.
17. The output of this heater may vary and its
temperature may become intense enough to
burn exposed skin. Use of this heater is not
recommended for persons with reduced
sensitivity to heat or an inability to react to
avoid burns.
18.
SAVE THESE
INSTRUCTIONS
DO
ASSEMBLY
• Remove the Handle from the box.
• Place the heater on a firm, level floor.
• Line up the prongs on the bottom of the handle with the openings on the
top of the heater and firmly push down (Fig. 1). The handle is now
permanently fastened to the top cover.
Fig. 1
SET-UP
• Place the heater on a firm, level, open surface free from
obstructions and at least 3 feet (0.9m) away from any wall or any
combustible material. DO NOT use on an unstable surface such as
bedding or deep carpeting. BE SURE THE HEATER IS NOT IN A
POSITION WHERE IT MAY BE TRIPPED OVER BY SMALL
CHILDREN OR PETS.
• The Tower Surround Heater is designed to disperse heat in either a
360° range or in one direction only.
• To select the desired heating mode, slide the Direction Control
switch, located on the top of the heater, to the position of your choice (Fig. 2):
– to the left (full circle) for 360° Heating
– to the right (half circle) for Forward Only Heating (One Direction Heating)
Fig. 2
360° Heating
Forwad Only
Heating
(One Direction
Heating)
OPERATION
• Select the appropriate heat dispersion mode (See Set-Up).
• With the Power knob in the OFF (O) position, plug the heater into
a polarized 120V outlet.
• Turn the Thermostat control fully clockwise to the HIGH setting.
• This heater is equipped with three different heat settings. The
Low setting (I) uses 600 watts of power, the Medium setting (II)
uses 900 watts of power and the High setting (III) uses 1500
watts of power. You can select the proper setting to
accommodate your comfort level. Because the Low and Medium
heat settings do not require as much electricity to operate, they
are more energy efficient and may be better options if you are concerned about the amperage
draw on a circuit when the heater is in the High setting.
• Turn the heater on using the Child Resistant switch (Power knob). To operate the switch,
down the two sides of the Power knob while turning it clockwise to the desired position (Fig. 3).
The power light will illuminate. The Child Resistant switch helps to keep the heater from being
turned on unintentionally.
• When the room reaches a comfortable temperature, slowly turn the Thermostat control counterclockwise until the heater goes off. This is the point at which the Thermostat setting equals the
room temperature. At this setting, the Thermostat will automatically turn the heater on and off to
maintain this selected temperature.
• Push down and turn the Power knob to OFF and unplug the heater when you are finished
using it.
Fig. 3
push
ELECTRICAL RATING
This product is rated 12.5
Amps (1500 watts) @ 120V
, 60Hz
SAFETY FEATURES
This heater is equipped with several devices and features for added protection:
• Child Resistant push-to-turn power control knob.
• A tip-over switch that disables the heater if it is accidentally tipped forward or backward.
• A high temperature safety control prevents overheating (HI limit).
• This heater is also equipped with a thermal cut-off fuse that will permanently shut down the
heater should it operate at a higher than normal temperature.
• This heater was created using a high quality safety plastic.
TROUBLESHOOTING
If your heater shuts off unexpectedly or fails to operate, one of your heater safety features may have
been activated to prevent overheating.
• Be sure it is plugged in and that the electrical outlet is working.
• Check your Thermostat setting. The unit may simply be off because you have reached your
desired heat setting.
• Check for any obstructions. If you find an obstruction, turn the heater OFF and unplug it. Allow
the heater to cool completely, then remove the obstruction. Wait at least 10 minutes, then re-plug
the heater in and follow the OPERATION instructions.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE
WARRANTY FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE
HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE
OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CALL OR WRITE:
Kaz, Inc. - Consumer Relations Dept.
Toll Free: 1-800-332-1110
Email us at: consumerrelations@kaz.com
Mail questions or comments to:
Kaz, Inc.
Attn: Consumer Relations Department
250 Turnpike Road
Southborough, MA 01772 U.S.A.
Please be sure to specify model number.
CLEANING AND STORAGE
CLEANING
We recommend that the heater be cleaned at least once a month and before off-season storage.
• Turn the heater OFF and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER,
WAXES, POLISHES OR ANY CHEMICAL SOLUTION.
STORAGE
• Clean your heater using the above-mentioned steps, then store it in a cool, dry place.
• This heater does not disassemble.
5 YEAR LIMITED WARRANTY
You should first read all instructions
before attempting to use this product.
. This 5 year limited warranty applies to
A
repair or replacement of product found to
be defective in material or workmanship.
This warranty does not apply to damage
resulting from commercial, abusive,
unreasonable use or supplemental
damage. Defects that are the result of
normal wear and tear will not be
considered manufacturing defects under
this warranty.
KAZ IS NOT LIABLE FOR INCIDENTAL
OR CONSEQUENTIAL DAMAGES OF
ANY NATURE. ANY IMPLIED
WARRANTY OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR
PURPOSE ON THIS PRODUCT IS
LIMITED IN DURATION TO THE
DURATION OF THIS WARRANTY
.
Some jurisdictions do not allow the
exclusion or limitation of incidental or
consequential damages or limitations on
how long an implied warranty lasts, so
the above limitations or exclusions may
not apply to you. This warranty gives you
specific legal rights, and you also may
have other rights which vary from
jurisdiction to jurisdiction. This warranty
applies only to the original purchaser of
this product from the original date of
purchase.
B. At its option, Kaz will repair or replace this
product if it is found to be defective in
material or workmanship. Defective
product should be returned to the place of
purchase in accordance with store policy.
Thereafter, while within the warranty
period defective product may be returned
to Kaz.
C. This warranty does not cover damage
resulting from any unauthorized attempts
to repair or from any use not in
accordance with the instruction manual.
D. Return defective product to Kaz, Inc. with
a brief description of the problem. Include
proof of purchase and a $10 US/$15.50
CAN check or money order for handling,
return packing and shipping charges.
Please include your name, address and a
daytime phone number. You must prepay
shipping charges. Send to:
In U.S.:
Kaz, Inc.
Attn: Returns Department
4755 Southpoint Drive
Memphis, TN 38118
USA
In Canada:
Kaz, Inc.
Attn: Returns Department
510 Bronte Street South
Milton, ON L9T 2X6
Canada