Honeywell CP-50 User Manual

CP-50 Water Purifier

Product Installation & Operation Manual

Honeywell Environmental & Combustion Controls

(Tianjin) Co., Ltd.

Catalog

Important Notes

Safety Precautions

Product Functions

Product Features

Installation Instructions

Operation Instructions

Care & Maintenance

Warranty Provisions

P2

P3

P4

P5

P6-P7

P8

P9

P10

Packing List

P11

1

Important Notes

Users must install the water purifier with the help of professionals by st­rictly following the installation specification set out in the "Product Insta­llation & Operation Manual" (hereinafter referred to as manual), and use
the water purifier according to the instructions in the manual. Otherwise
the company does not assume any economic or legal responsibility for
the water purifier damage or leakage and consequential property dam­age due to improper installation and usage of water purifier.

1. Check the water purifier and pipe fittings regularly to see whether th­ere is any leakage, and avoid property damage caused by leakage.

2. The water purifier is only intended for household use, and may not
be suitable for other purposes.

3. For the water purifier maintenance and filter cartridge replacement,
use the replacement parts authorized by Honeywell Environmental &
Combustion Controls (Tianjin) Co., Ltd..Quality problems, degradation
of operational performance or property damage caused by using una­uthorized parts or accessories are not covered in the guarantee.

4. Maintenance of the water purifier and filter cartridge replacement
are paid services.

2

Safety Precautions

At the inlet of the water purifier, the water quality must be the municipal
tap water quality which meets local standard.

Do not install the water purifier in the water supply pipe, whose press­ure exceeds 0.6MPa. If the water inlet pressure exceeds 0.6 MPa, the
pressure reduce valve (purchased separately) must be installed.

The water inlet temperature range of the water purifier is 5 ~ 38°C;wat­er temperature exceeding 38°C may damage seals and cause leaka­ge; water temperature below 5°C may cause water to freeze and lead
to the pipe rupture and leakage.

Install the filter cartridge in a correct order, otherwise the water purifier
cannot perform its intended function.

Do not install the water purifier reversely, and connect the water inlet
pipe to the outlet.

Do not install the water purifier in direct sunlight or at a places where it
is exposed to hazardous chemicals or may be damaged by falling or
collision.

Do not install the water purifier near any source of heat.

Do not install the water purifier upside down.

3

Exterior Features

Product Functions

220mm

321mm

Figure 1

122mm

Technical Parameters

Model

Water inlet pressure

Water inlet temperature

Purified water flow rate

Rated maximum capacity

Water inlet requirement

* The rated maximum capacity is the effective treatment capacity after adding the standard
solution in the whole process according to the inspection rules required by Ministry of Health.
The actual water treatment capacity may vary depending on local water quality and operating
environment.

Municipal tap water, conforming to local standard

Table 1

CP-50

0 .2MPa～0.6MPa

5–38°C

1.5 L / Min

*800L

4

Installation Instructions

Input

Filter adapter

Figure 2

Outlet

Lead removal ACF

MS composite molecular sieve
（sterilization）

Preparations before Installation

1. Confirm the location before installing the water purifier. (It depends on the actual ins­tallation)

2. Make sure all accessories required for installation are complete.(See packing list)

3. Turn off the water inlet valve before installation.

Installation Steps

110mm

Figure 3

Step 1：

Fix the filter adapter with screws, as
shown in Figure 3.

Figure 4

Step 2：

Assemble lead removal ACF cartridge to
the first stage of the filter adapter , and
MS composite molecular sieve filter
cartridge (sterilization) to the second
stage of the filter adapter.
Align the two pipes of the cartridge to the
connection holes in the wall, and rotate
counter-clockwise to the end.

6

Installation Instructions

Installation Steps

Ring

Nut

Nut

Plug

Ring

Plug

Cold water pipe

connection nut

Sealing gasket

Tee joint

Sealing gasket

Cold water valve

Wrapped
with PTFE
tape

Ball Valve

Ball Valve nut

1/4" PE pipe

Lead removal ACF

filter cartridge

MS composite
molecular sieve
filter cartridge
(sterilization)

Figure 5

Step 3：
Cut the 1/4”PE pipe into 2 sections. One section is used to connect tee joint ball valve
and filter adapter, and the other section is used to connect faucet and filter adapter, as
shown in Figure 5.

Figure 6

Step 4：Hang the whole set of the water purifier on the filter adapter screws.：

Wash and Start Water Purifier

1. Turn on the water inlet valve and small ball valve.

2. Open the faucet to let the water flow into the water purifier. Due to the role of carbon
particles and bubbles, the water may seem a little muddy at the start, which is normal.

3. Continuously flush new water purifier for about 10 minutes, until the water becomes
clear and no bubbles, and it can provide the drinking water.

7

Operation Instructions

1. Check water purifier and components regularly to avoid leakage,

which may cause damage to property.

2. When you go out or do not use the water purifier for a long time, pl-

ease shut off the water inlet of the purifier (turn off the water inlet b­all valve).
If the purifier has not been used for 24 hours, please flush it for 5-10
seconds. If the purifier has not been used for more than 5 days (mo­re than 3 days in summer) ,please flush it for 10 minutes before use.
Do not keep the filter unused for long after the water flows through,
especially in summer, generally no more than 14 days.

3. In case of any following situations, shut off the input water of the pu-

rifier (turn off the water inlet ball valve) immediately, and contact the
service provider as soon as possible.

If the pipe or related parts of the water purifier are leaking.
If the related components of the water purifier malfunction.
If any other anomalies or failures occur.

8

Care & Maintenance

The set of capacity and replacement time recommended for
filter cartridges at various stages

Filter cartridge name

Lead removal ACF

MS composite molecular

sieve (sterilization)

The set of capacity and replacement time may be adjusted based on the water quality
and usage.
Every filter cartridge of the product uses flow and time dual control. Whichever reaches
the set value, the faucet will give indication. See the faucet manual for details.

1. The recommended replacement cycles for various filter cartridges of the water purifi­er are estimated by referencing the average indicator of water supply at various regions.
When the water quality at the user's site and the purifier usage are quite different from
the average indicator, filter cartridge usage and estimated cycle may be significantly di­fferent,such as early clogging or failure of filter cartridge. The actual usage will be used
as the basis for replacing the filter cartridge, and contact the service provider for the
setting.

2. The estimation of filter cartridge usage cycle is based on the average household wa­ter consumption. The usage cycle is only suitable for household use, and may not be
suitable in public places with large water consumption.

Recommended handling

capacity

1.5-3 tons

1.5-3 tons

Table 3

Replacing the filter components

Recommended

replacement time

6-12 months

6-12 months

Lead removal ACF

MS composite molecular
sieve filter cartridge
(sterilization)

Figure 7

Figure 7

1. Align the filter cartridge with the filter adapter, and rotate clockwise until it stops. The
filter cartridge automatically comes off.

2. Select the corresponding replacement filter cartridge, align the 2 connection pipes
with the connections holes in the filter adapter, and rotate counter-clockwise until it stops.

3. When replacing the water purifier water cartridge, there is no need to turn off the water
inlet valve, because the filter adapter will automatically turn off the water outlet.

4. When removing the filter cartridge, there may be a little water coming out of the filter
cartridge. Wipe the water off.

9

Warranty Provisions

Warranty period

1.

We provide one year warranty for the whole product, but consumables are not cover­ed (consumables include various filter cartridges).
Note: The water purifier is only intended for household use, and may not be suitable
for commercial sites.

2. Warranty conditions

Users should follow the following rules, or else the warranty rights will be voided.

● Users should purchase the product from legal sellers through legal ways.

● Users should keep the invoice and the manual in a safe place.

● The product should be installed by service teams authorized by Honeywell

or qualified installation teams authorized by the State authority.

● The supplied manual must be strictly followed when using the product.

3. Exceptional conditions

Product malfunctions or damages in the following situations are not covered in the
warranty：

1) Purchase the product through illegal means or illegal ways.

2) Products without invoice or proof materials.

3) Product malfunctions or damages caused by installation of the unqualified team
or without guidance of the manufacturer.

4) Use non-authorized parts or accessories.

5) Malfunctions or damages caused by improper use and breaking the rules of the
product manual.

6) Malfunctions or damages caused by forced use under abnormal conditions.

7) Damages caused by force majeure.

8) Products repaired by non-authorized staff.

4. Warranty service

Our company will provide comprehensive warranty service for the malfunctioned and
damaged products within the warranty period if they comply with the warranty condi­tions and do not comply with any exceptional conditions. The warranty services incl-

ude:

● Repair the malfunctioned products for free;

● Replace the malfunctioned parts for free;

● Other services specified in the State regulations, including local laws.

5. Warranty service procedure

1) When the product malfunctions, turn off the water immediately. After verifying that
it meets all the requirements, contact the specified service provider immediately.

2) When the maintenance staff provides on-site services, the user should provide va­ lid invoice and describe the service conditions and malfunctions. After verifying the
product, the maintenance staff will carry out inspection and repair.

10

Packing List

No

1

2

3

4

5

6

7

8

Item Quantity

Filter adapter

Lead removal ACF filter cartridge

MS composite molecular sieve filter

cartridge (sterilization)

1/4”PE white pipe

Accessories

1/4” tee joint

1/2” ball valve

Screw

Manual

Table 4

1 set

1 set

1 set

2.0 m

1 pcs

1 pcs

2 pcs

1 pcs

11

Honeywell Environmental & Combustion Controls
(Tianjin) Co., Ltd.

No. 158, NanHai Road
Tianjin Economic-Technological Development Area
Tianjin, 300457, P.R.C.
Phone: [phone]

Subject to change without notice

50085494-001