3
REVERSE OSMOSIS FILTRATION SYSTEM
This Reverse Osmosis (RO) filtration system
removes dissolved solids and organic matter from
water by passing it through a membrane which
separates and flushes minerals and impurities
from the water.
Install this system upstream of the steam humidifier’s water inlet. It is recommended that the RO
system’s filters be replaced at least once per year
to ensure optimal humidifier performance.
SAFETY GUIDELINES
Read, understand and follow all steps, guides
and requirements before installing the Reverse
Osmosis (RO) filtration system.
All water connections must comply with local
and state plumbing and sanitation codes.
Reference, understand and comply with all governing codes before installing the RO filtration
system.
Do not install on hot water supply. Only use
cold water supply.
Do not install outside or in unconditioned space
where there is potential for the water system to
freeze.
OTHER REQUIREMENTS
If the RO filtration system or the humidifier are installed in finished space or above ceilings, it is required
to install a water drip pan with a shutoff sensor under all water connections.
See steam humidifier manual, Appendix C.
TOOLS NEEDED
Crescent wrench
Philips screwdriver
PARTS INCLUDED
ALL MODELS
RO System Assembly
– RO manifold assembly
– Supply tubing (one 20 ft. long 1/4” dia.
white tube)
– Adapter elbow (3/8” x 1/4”)
– Drain line assembly (including one 6.5 ft.
long 1/4” dia. red tube, one 1 ft. long
1/4” dia. red tube, and drain flow restrictor assembled in drain line fitting)
– Mounting screws and washers
Water Filters
– #1 - Sediment filter
– #2 - Reverse osmosis filter
– #3 - Staging tank
SELECT MODELS (as listed)
Water Storage Tank
(Models 50045947-001 & 50045947-002)
– Storage tank
– Storage tank tubing (one 6 ft. long 3/8”
dia. yellow tube)
– Shutoff valve
– Teflon tape
Permeate Pump (Model 50045947-002)
– Permeate pump
– Mounting bracket and screws
– Tee fitting
Plug Fitting (Model 50045947-003)