INSTRUCTIONS & PARTS LIST
LIFT LEVER
LIFT CABLE ASSEMBLY-^
QUICK PIN
HITCH ASSEMBLY
42” GRADER BLADE
No. LM-99IOI3
for T-I0,T-I2, T-15,
T-I6H, & T-I6S TRACTORS
TRANSPORT HOOK
[See figure 1)
KING PIN
QUICK PIN
The 42" grader blade is attached to the tractor as shown in
the above illustration by following the sequence of steps as
outlined below.
UNDERSIDE OF TRACTOR
FRONT
P^^ORAW BAR ASSEMBLY
P
ROD ^
PULLEY
LIFT ROD
QUICK PIN
FIGURE
Attach the lift cable to the rod on the lift lever located
on the underside of the tractor (see Fig. 2). Run the
cable over the pulley and attach to the lift rod on the
draw bar. Secure with a quick pin.
1. Position the .grader blade under the tractor so that the
draw bar assembly may be connected to the front hitch
brackets of the tractor. Secure in place with two clevis
pins and two quick pins.
When desired, the blade may be angled to the left or
right by removing the king pin and quick pin from the
center hole in the hitch assembly. Lock the blade in
the desired position by replacing the king pin and quick
pin when the alternate holes in the hitch assembly line
up with the hole in the draw bar.
PART NO. 24696-4
Supersedes No. 24696
42" GRADER BLADE
No, Description Part No.
1
CABLE ASSEMBLY-lift LM-16064-73 1
WASHER-lock, 5/8
2
3
NUT-hex, 5/8-11
4 BRACKET ASSEMBLY LM-01727-38
5 BLADE-grader, 42" LM-01070-56 1
- 6 WASHER-lock, 3/8 LM-09169-65 1
^ 7
HOOK-trails port lift LM-01779-73
8 WASHER-flat, 3/8 LM-09173-78 1
■ 9 SCREW-hex cap, 3/8-16 x 1-1/4 LM-09174-00
10 NUT-hex, 3/8-16 LM-09234-28
LM-09173-73 3
LM-09157-26
ALWAYS FURNISH MODEL AND SERIAL NUMBER WHEN ORDERING PARTS.
HOMELITE^
PRINTED IN U.S.A.
PORT CHESTER, NEW YORK. U.S.A. 10573
Qty.
3
No. Description
11
12
13 PIN-king
14 PIN-quick
1
15 PIN
*16
17 PIN-quick
1
18
1
1
^ taxtfonl
OtVISION
HITCH ASSEMBLY
SCREW-hex cap, 5/8-111 x 3
DRAW BAR ASSEMBLY
WASHER
Accessory
PAINT-black, 12 oz. spray v^an
Part No. Qty.
LM-01070-58
LM-09221-18
LM-81810-08 1
LM-01067-88 3
LM-01180-53 2
LM-01070-62
LM-80210-24
LM-01212-10 2
22772
3
1
1
1