Holux GPSmile53B User Manual

GPSmile 53 Portable Automobile
Navigation System
Quick Started Guide
Version: V.01
January 2007
Registered info
All other trademarks belong to each registered companies.
Note
z Contents of this manual will be modified without further notice. z The proper operation temperature of the product is between 0℃~40℃.
Operating or recharging in an environment with temperature over 45 might cause system to stop functioning. yet this should be considered as a
normal phenomenon. Please do not operate in an extreme temperature environment.
Operating Methods
Startup
1. For first time use, please turn the system power switch at the rear side On.
2. Press and hold the power button for about two seconds to turn on the power.
Note: Before the first time use, please switch the system power on.
System power switch
Shutdown
1. While power is on, press the power button to turn off power.
2. If the unit will not be used for a long time, turn the system power switch at the rear side Off.
Power button
Using Vehicle Bracket
The included in vehicle bracket set can be securely suctioned on the front windshield, or using the adhesive plate, securing on top of the glove compartment. This device will effectively secure the GPS unit in the vehicle. Follow the procedures below to secure the bracket:
1. Follow the arrows and slide the unit into the in-vehicle bracket fitting holes to secure.
2. Gently push down until the unit is tightly fixed with the bracket.
Note: Please note the directions of the arrows, when fitted the assembly should be tight. If these directions are not followed, a loose fit will result, and components must be reassembled.
3. Bend the bracket support to a proper angle. Suction the vehicle bracket securely to the windshield, ensuring its base is resting firmly on the dashboard.
4. Follow the directions to insert the bracket into the slots on the bracket, and slide to fix the set (A Æ B).
5. The in vehicle bracket assembly is complete.
9 When using the in-vehicle secure
bracket, do not install in a location that will block the view of the driver
9 Recommended installation requirements:
The bracket base should be resting securely on the dashboard to prevent excessive shock.
Using the Car Charger
While using the device in a vehicle, use the included car charger for long periods of usage.
1. Plug in the small plug into the power jack on the rear of the in vehicle bracket.
2. Insert the other end into the cigarette lighter.
System Reset
Only under extremely few circumstances will it be required to reboot the system. Reset your system if the following situations occur:
1. Heavy lag experienced with screen refresh or operations, resulting in an inoperable system.
2. Cannot turn off the system with power button.
3. No response with selection on the screen.
If any of above occurs, turn the system power switch at the rear side Off
and turn it back On to reboot the system.
Main Menu
During the first startup, the screen will show the main screen consisting of four functions: navigation, music, photo, and settings. Directly select the icon onscreen to use the function.
System power switch
GPS Loads the navigation program and navigation
screen Note: If the SD card with navigator software is
inserted, the system will enter GPS function automatically after startup.
Music Plays MP3 music
Photo Plays images
Other Enter expansive functions (Video, eBook) and
system setup
Loading...