Hobart ML-104858 User Manual

I

N

S

T

R

U

C

T

I

O

N

S

A200 MIXER

MODEL

A200 ML-104859 (without Timer)

ML-104858 (with Timer)
ML-104863 (Deluxe Finish with Timer)
ML-104861 (Floor Model with Timer)

701 S. RIDGE AVENUE

TROY, OHIO 45374-0001

937 332-3000

www.hobartcorp.com

FORM 34387 (Feb. 2000)

MODEL A200 MIXER

– 2 –

Installation, Operation, and Care of

A200 MIXER

SAVE THESE INSTRUCTIONS

GENERAL

The model A200 mixer is a 20 quart, bench-type mixer with a 1/2 H.P. motor, and a #12 attachment hub.
With the use of special agitators, a 12 quart bowl may be used on the A200 mixers.

The floor model and the deluxe finish model are equipped with a timer.
Most A200 mixers are equipped with a 0 - 15 minute timer.
There are a variety of attachments and accessories available for all models, and these are explained

in a separate

Use and Applications Handbook

which is supplied with each mixer.

INSTALLATION

UNPACKING

Immediately after unpacking the mixer, check for possible shipping damage. If this machine is found
to be damaged after unpacking, save the packaging material and contact the carrier within 15 days of
delivery.

Prior to installation, test the electrical service to assure that it agrees with the specifications on the
machine data plate.

LOCATION

Place the mixer on a suitable sturdy level surface. There should be adequate space around the mixer
for the user to operate the controls and install and remove bowls.

Holes are provided in the base to permanently secure the mixer, although this is not necessary in
normal installations. Four plastic plugs are supplied with the mixer to plug these holes if they are not
used.

ELECTRICAL CONNECTIONS (Cord Connected Mixers)
WARNING: THE ELECTRICAL CORD ON THIS MACHINE IS EQUIPPED WITH A THREE-PRONGED

GROUNDING PLUG WHICH MUST BE CONNECTED TO A PROPERLY GROUNDED RECEPTACLE.
IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN.
DO NOT REMOVE THE GROUNDING PRONG FROM THE PLUG.

– 3 –