3
Important safety instructions
General safety and daily use
It is important to use your
appliance safely. We
recommend that you follow the
guidelines below.
●
Store any food in accordance with
the storage instructions from the
manufacturer.
Don't try to repair the appliance
●
yourself. It is dangerous to alter the
specifications or modify this product in
any way. Any damage to the cord may
cause short circuit, fire or electric
shock.
●
Don’t place too much food directly
against the air outlet on the rear wall of
both the refrigerator and freezer
compartment, as it affects sufficient air
circulation.
Don't place hot items near the plastic
●
components of this appliance.
To avoid items falling and causing
●
injury or damage to the appliance, do
not overload the door racks or put too
much food in the crisper drawers.
Safety for children and infirm persons
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities, or a
lack of experience and knowledge,
unless they have been given
supervision or instruction concerning
the use of the appliance by a person
responsible for their safety. Children
should be supervised to ensure that
they do not play with the appliance.
Keep all packaging away from
●
children to avoid risk of suffocation.
Protect children from being scalded
●
by touching the very hot compressor at
the rear bottom of appliance.
Don't place items on top of the
●
appliance as this could cause injury
should they fall off.
Never allow children to play with the
●
appliance by hanging or standing over
or on the doors, racks, shelves and
drawers etc.
●
Safety about electricity
To avoid the risks that are
always present when using an
electric appliance, we
recommend that you pay attention to
the instructions about electricity below.
We recommend after you unpack
●
the appliance and check through the
appliance. Should any damage be
evident, don't plug in the appliance but
contact the shop immediately from
which you purchased it. Keep all
packing materials in this case.
The appliance must be applied with
●
single phase alternating current of
220~240V/50Hz.
The mains plug must be accessible
●
when the appliance is installed.
Make sure that the appliance is
●
grounded properly. If still in doubt, call
a qualified registered electrician.
If the fitted plug is not suitable for
●
your socket outlets, it should be cut off
and carefully disposed of. To avoid a
possible shock hazard, do not insert
the discarded plug into a socket. If in
doubt contact a qualified, registered
electrician.
Do not use extension cords or
●
multiple sockets which could cause
overloading of wiring circuits and could
cause a fire.
Always plug your appliance into its
●
own individual electrical socket which
has a voltage rating that matched the
rating plate.
Make sure that the plug is not
●
squashed or damaged. Otherwise, it
may cause short circuit, electric shock
or overheat and even cause a fire.
Don’t insert the mains plug if the
●
socket is loose, there is a risk of
electric shock or fire.
●
Switch off the appliance and
disconnect it from the mains power
before you clean or move it.
Never unplug the appliance by
●
pulling on the electrical cord. Always
grip the plug firmly and pull straight out
from the socket to prevent damaging
Hisense Refrigerator
5
Installing your new appliance
Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation of appliance
In order to improve efficiency
of the cooling system and
save energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.
For this reason, sufficient clear space
should be available around the
refrigerator.
Suggest
:It is advisable for there to be
at least 75mm of space from the back
to the wall, at least 100mm from its
top,at last 100mm from its side to the
wall and a clear space in front to allow
the doors to open 135°. As shown in
following diagrams.
≥75mm
≥ 100mm
≥ 100mm
700mm
1746mm
≥ 100mm
1200mm
1022mm
Note:
● This appliance performs well within
the climate class from showed in
NtoT
the table below.
It may not work properly if being left at
a temperature above or below the
indicated range for a long period.
Ambient Temperature
Class
Extended
Temperate
Temperate
Subtropical
Tropical
●
Stand your appliance in a dry place
Symbol
SN
N
ST
T
range()°C
+10 to +32
+16 to +32
+16 to +38
+16 to +43
to avoid high moisture.
●
Keep the appliance out of direct
sunlight, rain or frost. Stand the
appliance away from heat sources
such as stoves, fires or heaters.
Leveling of appliance
●
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
●
To allow the door to self-close, tilt the
top backwards by about 10mm.
≤10mm
Adjusting the door handle
Before you use the appliance, please check
the refrigerator handle. If the handles is
loose, please adjust them by using an Allen
wrench in the clockwise direction until
handle is securely in place. the handle is
fitted with 2 screws.
Hexagon socket
set screws
Allen wrench
Hisense RefrigeratorHisense Refrigerator
Description of the appliance
View of the appliance(HR6AFF355SD,HR6AFF355D)
Upper cover
1.
Block cover
2.
3
. LED light
Glass shelf
4.
Cabinet
5.
Small glass shelf
6.
7. Crisper box
Crisper cover
8.
Humidity control sliding block
9.
Moisture fresh crisper
10.
Adjustable bottom feet
11.
Hinge cover
12.
Upper cover of door
13.
Corner cover
14.
Egg tray(inside)
15.
Upper rack
16.
17. Handle(back)
18. Lower rack
19. Bottle holder(inside)
20. Fridge door
21. Fridge door seal
1
2
3
4
5
6
7
8
9
10
11
6
12
13
14
15
16
17
18
19
20
21
Note: Due to constant improvement of our products, your refrigerator may be
slightly different from this illustration manual, but its functions and using methods
remain the same.
Note: To get the best energy efficiency of this product, please place all shelves,
drawers and baskets on their original position as the illustration above.
Hisense Refrigerator