Hilti HCI-WF-MD INSTALLATION
M
echanical Anchoring Systems
4.3.10 HCI-WF/MD Cast-In Anchor
4.3.10.4 Installation Instructions
nstallation Procedure for HCI-MD
I
1. Prior to pouring concrete, drill
a hole through the metal
deck, using the specified
diameter metal hole saw.
2. From the topside of the deck,
place the plastic sleeve
through the hole.
Installation Procedure for HCI-WF
1. Prior to pouring the concrete
over the wood form, place the
anchor (nails down) on the
surface of the wood form.
2,3. Drive the anchor down until flush with the surface of the wood
form. When all anchors are installed, pour the concrete. When
wood form is removed, the three break-off nails usually remain.
Wearing eye protection, remove these nails.
4.3.10.5 Ordering Information
HCI – WF Cast – In Anchor
for use in W
Description Content Item No.
HCI – WF 1/4" 150 00282907
WF 3/8" 150 00282908
HCI –
HCI – WF 1/2" 100 00282909
WF 5/8"
HCI –
HCI – WF 3/4" 100 00285928
ooden Form
Packaging
100 00285927
3. By stepping on the head of
the anchor (or by using a
hammer), push it through the
hole until the anchor plastic
sleeve snaps into place (i.e.
the deck is between the
sleeve and the flange of the
anchor). After all inserts are
installed, pour the concrete.
4. After the concrete has properly cured and achieved its
design compressive strength,
install the threaded rod,
ensuring full thread engagement. (Note: Rod may be
installed prior to concrete
pour, but should not be
loaded or disturbed until concrete has cured and achieved
its design compressive
strength .
4. After the concrete has properly cured and reached its
design compressive
strength, install the threaded
rod, ensuring full thread
engagement.
Color Identification Decals
for use with HCI – WF
Description Content Item No.
Packaging
HCI – WFID Decal Color: Blue 300 00284256
WFID Decal Color: Green 300 00284257
HCI –
HCI – MD Cast – In Anchor for use in Metal Deck & Accessories
Description Content Item No. Diameter Item No. Item No.
HCI – MD 1/4"
Packaging Hole Saw Hole Saw Hole Saw Arbor
100 00282910
7/8" 00283131
HCI – MD 3/8" 100 00282911 7/8" 00283131 00283124
HCI – MD 1/2" 60 00285929 1-3/16" 003001812 00283124
HCI – MD 5/8" 60 00282912 1-3/16" 003001812 00283124
HCI – MD 3/4" 60 00285930 1-1/4" 00283134 00283126
Color Identification Decals for use with HCI – MD
Description Content Item No.
Packaging
HCI – MDID Decal Color: Blue 300 00284258
HCI – MDID Decal Color: Green
260 Hilti, Inc. (US) 1-800-879-8000 | www
300
.us.hilti.com
I en español 1-800-879-5000 I Hilti (Canada) Corp. 1-800-363-4458 I www
00284259
00283124
.ca.hilti.com
I Pr
echnical Guide 2006
oduct T
Loading...