Henny Penny OFE- 291 Installation Manual

SECTION 2. INST ALLA TION

Model OFE- 291

2-1. INTRODUCTION

2-2. UNP ACKING

INSTRUCTIONS

This section provides the installation and unpacking instructions for
the Henny Penny model OFE-291.

Installation of this unit should be performed only by a qualified
service technician.

Do not puncture the fryer with any objects such as drills
or screws as component damage or electrical shock
could result.

Any shipping damage should be noted in the presence of the
delivery agent and signed prior to his or her departure.

1. Cut and remove the metal bands from the carton.

2. Remove the carton lid and lift the main carton off the fryer .

3. Remove corner packing supports (4).

4. Cut the stretch film from around the carrier/rack box and
remove it from the top of the fryer lid.

5. Cut and remove the metal bands holding the fryer to the
pallet.

All counterweights must be loaded before unlatching the
lid, or personal injury could result.

6. Remove the fryer from the pallet.

T ake care when moving the fryer to prevent personal
injury . The fryer weighs approximately 600 lbs.
(270 kg).

803 2-1

Model OFE- 291

2-2. UNP ACKING

INSTRUCTIONS
(Continued)

7. Remove the counterweights from the pallet, which are

strapped to the pallet, under the fryer .

Do not drop. The counterweights weigh approximately
18 lbs. (8.1 kg.) each. Handle with care, or personal
injury could result.

8. Remove rear cover.

9. Load the 4 weights into the counterweight assembly . See

next page.

10. Replace rear cover .

11. Cut warning tags from the lid assembly. The lid may now

be unlatched.

12. Remove the accessories from inside the filter drain pan.

13. Remove the protective paper from the fryer cabinet. Clean

exterior surface with a damp cloth.

Optional Ramp Unloading

2-2 404