User Guide
HTFS 3/E
Speaker stands
Designed to Entertain.
™
HTFS 3/E
Speaker stands
Included
Stand rails
Stand bases
ASSEMBLY INSTRUCTIONS
Note: HTFS 3/E stands are for use with
HKTS 20, HKTS 30, HKTS 60 and HKTS 200
satellite speakers (not included)
ASSEMBLY
1. Attach a stand rail to a stand base
End of rail
with cutout
Flat-head
screw
Speaker adapters
Flat-head
screws
Oval-head
screws
2. Attach a speaker adapter to the stand rail
Press adapter
into rail
Oval-head
screw
3. Run the speaker wire
through the stand base
Feed
through
hole
Wire
(included with speakers)
Bring
wire out
4. Remove the speaker’s base
HKTS 20 / HKTS 30 / HKTS 60 / HKTS 200 Speakers
Push UP
on corners
Push base
off speaker
+
–
5. Connect the speaker wire to the speaker
HKTS 20 / HKTS 30 / HKTS 60 / HKTS 200 Speakers
A. Push cap down B. Insert bare wire C. Release cap
ENGLISH
6. Attach the speaker to the stand rail
Slide speaker
onto stand rail
Fit
speaker rails
onto grooves
in stand rail
7. Bring the speaker wire out of the base
Bring wire out
through notch
Features, specifications and appearance are subject to change without notice.
Harman Kardon is a trademark of Harman International Industries,
Incorporated, registered in the United States and/or other countries. Designed
to Entertain is a trademark of Harman International Industries, Incorporated.
©2009 Harman International Industries, Incorporated. All rights reserved.
Harman Consumer Group, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
516.255.4545 (USA only)
www.harmankardon.com
© 2009 Harman International Industries,
Incorporated.
All rights reserved. Tous droits réservés.
Part No. 444020-001, 444021-001
Loading...