Grundig G2000A User Manual

Batteries

VOLUME

FM MW SW1 SW2

EARPHONE SOCKET

DC 4.5V SOCKET

MONO/STEREO

MEMO/
TIME SET

ALARM

MODE

1…0

LIGHT

H / M

POWER

LOCK

METER

RADIO/BUZZ

SLEEP

RESET

FREQ

CONTROLS

Leather cover

Your G2000A comes with a leather cover, which is use
both to protect the set and to use the radio in an inclines
position.

• Rotate the leather cover as shown in the illustration.
You can now use the set in an inclined position.

Notes

The unit meets the CEE regulations concerning
interference radiation.

This product fulfills European directives 89/336/EEC,
73/23/EEC and 93/68/EEC.

This set complies with the safety regulations according to
VDE 0860/BS 415 and thus with the international safety
regulations according to IEC 65.

The model number is located on the back of the set.

Controls _
DC 4.5 socket

Earphone
socket

MONO/STEREO
VOLUME
FM MW SW1 SW2
LIGHT
H / M

POWER
LOCK
METER
RADIO/BUZZ
SLEEP
BATTERIES

RESET
FREQ

1...0

MODE
ALARM
MEMO/
TIME SET

- connection socket for a mains
adapter

-socket for connecting stereo
headphones

-for mono/stereo selection

-for adjusting the volume

-band selector switch

-for illuminating the display

-for tuning to a radio station
for setting hours/minutes

-for switching the radio on and off

-for blocking all button functions

-for selecting the short-wave band

-for setting the alarm to radio or buzzer

-for switching on the sleep function

-inside the batteries compartment:

SW FREQ. selector
AM STEP selector

-for erasing the memory

-for entering frequencies

-for direct numeric entries (1 .. .0)
for selecting and storing preset
stations (1 .. .5)

-to change the display mode

-for switching the alarm on and off

-for programming stations into the
memory
for setting the time (HOME / DUAL /
ALARM)

Display

Display

The display provides information about the functioning of
your world receiver:

• While the radio is switched off, the current time will be
indicated. The first time it is used, or if the memory is
erased, ‘0:00’ will appear on the display.

• When the radio is switched on, the frequency in kHz
or MHz and the wave band FM, MW, SW1 or SW2 will
be indicated.
When the alarm is switched on, the alarm mode

•

(Alarm and radio or buzzer) will be
indicated.

• this indicator lights up when a certain station is
correctly turn to.

• indicates stereo reception for FM.

• SLEEP indicates that the sleep time function is active.

• LOCK indicates that all buttons are locked.

• indicates that batteries should be replace.

• MEMO lights up when you are storing stations.

Switch the display mode

You can change the information that appears on the
display of the G-2000A with the MODE button.
When the radio is off:

-The display shows the current time mode (HOME or DUAL
).

• If you wish to check the other settings, press MODE
briefly.

-The display changes each time you press the button.

-The display will return to the current time automatically

after five seconds (or press MODE briefly).

When the radio is on:

- The display shows the frequency.

• If you wish to check the other settings, press MODE
briefly.

- The display changes each time you press the button.

- The display will return to the frequency indication

automatically after five seconds (or press MODE briefly).