Greyline Instruments Stingray Quick Start Guide

Quick Start Guide

Stingray Level-Velocity Logger

1.

2.

3.

Install 4 Alkaline D-cell batteries (included).
Allow 10 seconds for the Stingray to activate
then press the button on the face of the
Stingray. The LCD display will turn On. If the
display does not turn On check that batteries
have been correctly installed. After 1 minute
the display will turn Off automatically.

Install Greyline Logger software on your
Windows PC or laptop computer. Insert the
CD and run Setup.exe. If you encounter error
messages during installation, open and review
the readme.txt file on the CD.

Connect the Stingray to your PC or laptop
with the RS232 cable (included0). Run
Greyline Logger and review the ‘Quick Start
Guide’ instructions which appear onscreen or
select the Help drop-down menu.

BATTERY +

+

BATTERY –

4.

5.

Configure Greyline Logger software
Communication Settings. Stingray baud rate is
fixed at 28800 Baud. Identify the serial port
on your laptop or PC. Refer to the Greyline
Logger ‘Help’ file ‘Connection Setup’ to for
detailed instructions if you are not sure which
COM port or virtual port your are connected
to. Greyline Logger also supports connection
though a USB/RS232 convertor or an
RS232/485 adaptor.

Configure the logging interval through
Greyline Logger software’s Real Time
Monitor. Select a logging interval and click
“Write” to properly initialize the Stingray.