Installation Instructions
for Single/Twin
Wall/Spike Lights
MODEL NUMBERS:
SS, GST, GWS, GWT
G
SAFETY
Important: This product should
be installed by a competent
person and in accordance with
the current IEE Wiring
Regulations. If in doubt consult
a qualified electrician.
WARNING
• Before installation, maintenance or lamp
replacement, ensure that the mains
supply to the luminaire is switched off
and the circuit supply fuses are removed
or the circuit breaker is turned off.
• Flexible cable must not be buried.
INSTALLATION
• Remove side cover undoing the 4 screws.
• Insert the Flexible Cable through the
waterproof gland attached to the side
cover.
NOTE
This appliance must be wired using 1mm
Flexible Cable, suitable for outside use.
• Strip back 35mm of the outer sheath of
the Flexible Cable.
• Cut back the green and yellow earth core
(as this fitting does not need an earth).
• Connect the Flexible Cable to the
terminal block as shown in Dia.1.
Dia. 1
• Replace the cover using the 4 screws
ensuring the flat edge is at the bottom
of the fitting.
• Tighten the gland to ensure a waterproof
seal.
• To fit the PAR 38 lamp/s, insert the
rubber seal into the top of lamp holder,
ensuring that the outer rubber ridge is
pushed completely into the lamp fitting.
The lamp can then be screwed into the
fitting.
NOTE
The unit may be extended to another spike
light by removing the blank sealing plug
and inserting a suitable waterproof gland
into the threaded hole.
2
Another length of 1mm2cable may be
inserted through this seal and connected to
your terminal block.
ECHNICAL SPECIFICATION
T
Rated Voltage: 230V AC 50Hz
Maximum Load: Single = 80W
Lamp Type: ES-E27, PAR 38
IP Rating: IP44
Class II double insulated
Twin = 2 x 80W
DISPOSAL
DDiissppoossaall ooff EElleeccttrroonniicc EEqquuiippmmeenntt WWEEEEE
DDiirreeccttiivvee 22000022//9966//EEC
This product falls within scope of the Waste
Electrical & Electronic Equipment Directive
(WEEE), which means the product should
ot be disposed of as normal household
n
waste. Ensure that this luminaire and lamp
is disposed of in accordance with the WEEE
Directive. Contact a local Council Waste
Dept. Local Amenity Site, or the DTI for
further information.
RoHS - All components and materials used
in this product are RoHS 2011/65/EU
compliant.
C
E
GUARANTEE
Your KingShield GSS, GST,GWS and
GWT are guaranteed for 12 months
from the date of purchase. This does
not affect your statutory rights.
PLEASE KEEP THESE INSTRUCTIONS
SAFE
FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sa le s@ gr ee nb ro ok .c o. uk
WW W. GREEN BRO OK. CO.UK
Issue No:
703365
Loading...