Gorenje BHC537X User Manual
EN
COOKER HOOD
User Manual
BHC537X
Recommendations
EN
and suggestions
• The Instructions for Use apply to
several versions of this appliance.
Accordingly, you may nd descriptions of individual features that do
not apply to your specic appliance.
• The manufacturer will not be held
liable for any damages resulting
from incorrect or improper installation.
• The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a lower
height, please refer to the paragraphs on working dimensions
and installation).
• Check that the mains voltage
corresponds to that indicated on
the rating plate xed to the inside
of the hood.
• For Class I appliances, check that
the domestic power supply guarantees adequate earthing. Connect
the extractor to the exhaust ue
through a pipe of minimum diameter 120 mm. The route of the
ue must be as short as possible.
• Do not connect the extractor hood
to exhaust ducts carrying combus-
tion fumes (boilers, replaces, etc.).
• If the extractor is used in conjunction with non-electrical appliances
(e.g. gas burning appliances), a
sufcient degree of aeration must
be guaranteed in the room in order
to prevent the backow of exhaust
gas. The kitchen must have an
opening communicating directly
with the open air in order to guarantee the entry of clean air. When
the cooker hood is used in conjunction with appliances supplied
with energy other than electric, the
negative pressure in the room must
not exceed 0,04 mbar to prevent
fumes being drawn back into the
room by the cooker hood.
• The air must not be discharged into
a ue that is used for exhausting
fumes from appliances burning
gas or other fuels (not applicable
to appliances that only discharge
the air back into the room).
• In the event of damage to the
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
• If the instructions for installation
for the gas hob specify a greater
distance specied above, this has
to be taken into account. Regulations concerning the discharge of
air have to be fullled.
• Use only screws and small parts
in support of the hood.
Warning: Failure to install the
screws or xing device in accordance with these instructions may
result in electrical hazards.
• Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
Use
• The extractor hood has been designed exclusively for domestic use
to eliminate kitchen smells.
• Never use the hood for purposes
other than for which it has been
designed.
• Never leave high naked ames
under the hood when it is in op-
3
Loading...