Goldmund EpiFoot Owner's Manual

THE GOLDMUND EPI-FOOT

EPILOGUE 1 FOOT SYSTEM

SETUP INSTRUCTIONS

WARNING !

Please check these instructions before assembling the feet with the Epilogue.
NOTE : The parts have been pre-assembled for test at the factory. It is perfe c t ly

normal that some metallic parts show some slight marking from this moun ting .

1. PRELIMINARIES

The Epi-Foot system is made to put a pair of Epilogue 1 to it s best son ic r esu lt .
It guarantees the perfect vibration evacuation by its steel heavy pointed pod.
It also sets the Epilogue 1 at the proper listening height, the same used in the

Epilogue1 + Epilogue 2 system as well as the full Epilogue system.
Please read carefully the following instructions to avoid asse mbly mistakes.

2. ASSEMBLY

The steel bar must be first attached t o the Epilogue 1 speaker. To do it easily it is
recommended that the Epilogue 1 is first placed on a soft mater ial direct ly on th e
floor, bottom side up and near its final placement.

Attention :

The screw mounted on the steel bar and which will be attached in side th e Epilo gue 1
frame is finely threaded. It is mandatory that the bar is screwed in very carefully and
perfectly perpendicular to the Epilogue 1 bottom plate. Any angle when the bar
thread is inserted may damage the steel parts.

Carefully screw the bar on the bottom of the Epilogue 1.
When the thread is fully inserted, you can tigh te n t he b ar strongly to apply its top to

the Epilogue 1 metal surface, in order to provide a good vibration path.
Leaving the Epilogue 1 on the floor with the bar sta nd ing - up , yo u will h ave t o pu sh

the foot assembly on top until the foot section covers the whole pod.

Attention :

To avoid a too hard friction from th e built-in neoprene isolation O-Rings, it is
recommended that liquid soap is applied on these internal rubber rings be fo r e
inserting the foot on the pod.

To now lift the speaker in position, it is recommende d to request the help of a second
person. Be careful that the poin ted extremity of the groundin g ba r can damage the
floor, carpet or other. The speaker an d the foot must be fully lifted when moved to
avoid such damage to occur.

Put the speaker in its final listening position and or ie ntation.
To properly adjust the feet, it is recommended to use the following procedure :
First lift the 4 adjustable feet to their h ighest position. Be careful that the speaker

becomes unstable. Have the second person maintain it vertical. Push the foot down
by hand to its lowest possible position.

2