Geovision GV-APOE0810 Installation Guide

January 3, 2019

1

GV-APOE0810 10-Port 10/100/1000M Unmanaged PoE

Switch with 8-Port PoE

1. Packing List

1. GV-APOE0810

2. AC Power Cord

3. Rubber Feet x 4

4. Rack Mount Kit

5. Screws x 8

2. Introduction

GV-APOE0810 is a 10-port 10/100/1000 Mbps unmanaged PoE Switch with 8 PSE/PoE
ports and 2 uplink ports. The switch supports IEEE 802.3at Power over Ethernet standard,
with up to 32 W per port and a maximum power consumption of 125 W. In addition to not
requiring special network cables for connecting your powered devices (PD), such as IP
cameras, its CCTV mode also allows power supply over cables of up to 250 m (820 ft) in
length, at 10 Mbps. It also gives you the option of VLAN mode to isolate each of the PoE
ports for an enhanced forwarding rate of time.

Note: If any of these items is found missing or damaged, please contact your local supplier
for replacement.

January 3, 2019

2

3. Front Panel

The front panel consists of 10 10/100/1000 Mbps ports, 8 PoE and 2 uplink, LED indicators
and the DIP switch.

LED Indicators

DIP Switch

10/100/1000 Mbps PoE Ports

10/100/1000 Mbps Uplink Ports

3.1 LED Indicators

LED

Color/Status

Description

PWR

Off

No power supply

Orange

System powered on

LINK/ACT

Off

No devices connected to the corresponding port

Orange

Network through the corresponding port has been
successfully established at 10/100 Mbps.

Green

Network through the corresponding port has been
successfully established at 1000 Mbps.

Blinking Orange /

Green

Data currently being sent through the
corresponding port at 10/100 (orange) or 1000
(green) Mbps

PoE

Off

No PoE powered devices (PD) connected

Orange

At least one device successfully powered through
PoE

Blinking Orange

Abnormal power supply

January 3, 2019

3

3.2 DIP Switch

The DIP switch can switch the system between Default, VLAN and CCTV modes, as
explained below:

[Default Mode] There can be communication between all 10 ports, and power can be
supplied through the 8 PoE ports over cables of up to 100 m (328 ft) with a network
bandwidth of 1000 Mbps per port.

[VLAN Mode] The 8 PoE ports function independently, cannot communicate with one
another, and can only communicate with the 2 uplink ports.

[CCTV Mode] Allows power supply over cables of up to 250 m in length, but at the expense
of reducing the network bandwidth of the 8 PoE ports to 10 Mbps per port.

Note: After switching between Default / VLAN / CCTV mode, the system must be
restarted for the change of mode to take effect.