TRUSS-CLAMP MOUNT 8260-465B for GENELEC 8260A
instruction manual
1. setup
1. The TRUSS-CLAMP
1. is ready for set up.
2. monitor mounting
2. Bolt together GENELEC 8260A and bracket.
2. Screw in five bolts M6x16 with washers.
2. Use an allen wrench SW5.
easy handling,
adjustable direction and angle
3. truss mounting
3. Tighten truss clamp to adequate
3. frame tube (2" / ΓΈ 51 mm).
3. Use washer, hexnut M12 and the
3. wing nut to secure the assembly.
instruction manual
4. settings 5. overhead suspension
4.b
DIRECTION
- Loosen central hexagon locking-nut
- Turn 8260A into desired direction
- Tighten central hexagon locking-nut
Safety Rope:
See VBG-document
BGI 810-3
>hanger assembly<
- Load capacity: Monitor GENELEC 8260A
- Choose a position and mounting method compliant with local building codes and regulations
- For use only by trained installers
- Inspect the condition of the parts and the bolted assemblies regularly
- Do not remove the split pin (see 4.b.X)
- For indoor use only
6. safety instructions
TRUSS-CLAMP MOUNT 8260-465B for GENELEC 8260A
easy handling,
adjustable direction and angle
GENELEC Oy
Olvitie 5, Fin-74100 Iisalmi, www.genelec.com
24492-000-55 Rev.06 03-80-483-00 3/13
4.a
TILT ANGLE
- Loosen both lateral hexagon locking-nuts
- Incline 8260A into desired angle
- Retighten both hexagon locking-nuts
- Place both end caps
Loading...