GE Industrial Solutions ANKT User Manual
g
p
g
quip
y
GEH6501 Installation Instructions R02
Spectra Series™ Power Panelboards
Type ANKT (200% Rated) Neutrals
WARNING: Danger of electrical shock or injury.
Turn
OFF
switchboard before workin
ment or removing any component.
e
ower ahead of the panelboard or
inside the
Equipment is to be installed and maintained b
properly trained and qualified personnel only.
Installation
1. Mount the neutral in the end of the panelboard
enclosure marked
Incoming Line, onto the
mounting studs, as shown in Figure 1. Fasten with the
1
/4-20 nuts, flat washers, and lock washers provided, as
shown in Figure 2. Tighten to 27–32 in-lbs.
2. Fasten the opposite end of the neutral to the
3
x
enclosure with the #10-32
/8" self-tapping screws
provided, as shown in Figure 1. Be sure to use all the
mounting holes. Tighten the screws to 27–32 in-lbs.
3. When a bonding strap is required for service entrance
applications, install the bonding strap to the
underside of the bus with the
1
/4-20 bolt, nut, lock
washer, and flat washers supplied, as shown in Figure
1
3. Use a 1
5
1
/8" bolt for 800 A and 1200 A applications. Tighten
/4" bolt for up to 600 A applications or a
the bolt to 40–50 in-lbs. Secure the opposite end of the
bonding strap to the neutral mounting base and box
back with the #10-32 self-tapping screw and lock
washer supplied, tightened to 27–32 in-lbs.
1
/4-20 Mounting
Studs
1
/4-20
Lock Washer,
Flat Washer
1
Box Back
/4-20 Mounting
Stud
Figure 2. Securing the neutral to the mounting studs.
1
/4-20 Bolt
and Flat
Washer
Flat Washer,
Lock Washer,
Nut
Bonding
Strap
Box Back
#10-32 Screw,
Lock Washer,
Flat Washer
Figure 3. Attaching a bonding strap.
Nut,
Bonding
Strap (when
required)
Use 10-32 x
Self-Tapping
Screws
3
/8
Figure 1. Installing the neutral in the enclosure.
g
These instructions do not cover all details or variations in equipment nor do they provide for every possible
g
p
contin
information be desired or should
purposes, the matter should be referred to the GE Company.
ency that may be met in connection with installation, operation, or maintenance. Should further
articular problems arise that are not covered sufficiently for the purchaser’s
GE Industrial Systems
General Electric Company
41 Woodford Ave., Plainville, CT 06062
GEH6501 R02 0501 © 2001 General Electric Company
Loading...