Garmin StreetPilot c320 Setup Guide

StreetPilot® c320

setup guide

This setup guide includes instructions to
configure your c320 and load maps.

To ensure a successful installation, follow

190-00435-02 Rev. C

the steps outlined in this guide.

connect the USB cable to your PC until you
are instructed to do so.

For information about using your c320, refer
to the

c320 Quick Reference Guide

the box. Also see the
at www.garmin.com/products/sp320/.

c320 Owner’s Manual

Do not

located in

Start Here

Open this setup guide and follow the instructions to set up your c320.
Complete all of the setup steps:

Step 1: Configure your c320
Step 2: Install software and map data
Step 3: Load maps

Do not connect the USB cable to your PC until you are instructed to do so.

Step 1: Configure Your c320

1

Press and hold the
Power button to turn
on the unit.

Note: A “Low Battery”
warning may appear when
you turn on the unit. Charge
the unit for three hours.

2

Answer the configuration questions that appear. When you
see the screen that states “To use this unit, map data must be
installed,” you are ready to install software and map data.

Volume control

USB cable connector

Power button