Garmin StreetPilot c320 Setup Guide, French [fr]

StreetPilot® c320

setup guide

This setup guide includes instructions to
configure your c320 and load maps.

To ensure a successful installation, follow

190-00435-70 Rev. A

the steps outlined in this guide.

connect the USB cable to your PC until you
are instructed to do so.

For information about using your c320, refer

c320 Quick Reference Guide

to the
the box. Also see the
on the DVD-ROM.

c320 Owner’s Manual

Do not

located in

Start Here

Open this setup guide and follow the instructions to set up your c320.
Complete all of the setup steps:

Step 1: Configure your c320
Step 2: Install software and map data
Step 3: Load maps

Do not connect the USB cable to your PC until you are instructed to do so.

Step 1: Configure Your c320

1

Press and hold the Power
button to turn on the unit.

Note: A “Low Battery”
warning may appear when
you turn on the unit. Charge
the unit for three hours.

Volume control

USB cable connector

Power button

2

Answer the configuration questions that appear. When you see the
screen that states “To use this unit, map data must be installed,” you
are ready to install software and map data.

Step 2: Install Software and

Map Data

1

Remove the DVD-ROM from the case and insert it into your
computer’s DVD-ROM drive.

If the startup file does not run automatically, click the Windows
button and select Run…. Type your DVD-ROM’s drive followed by
“Setup” (for example, “E:\Setup”). Click

OK.

2

Follow the series of instructions that appear on your computer. When
prompted, connect your c320 to your computer using the enclosed

USB cable.

3

When you have completed the
registration process, click
to load maps to your c320.

Done

Start