Garmin BKM-A User Manual

BKM4
Wireless Bike
Speed+Cadence
Monitor
M
OUNTING THE
S
PEED+CADENCE MONITOR ON
TO A BICYCLE FRAME
The BKM4 Bike Speed+Cadence Monitor mounts easily onto a bike frame. The speed monitoring unit is positioned on the back of the rear triangle; the cadence monitoring unit is positioned on the bottom of the rear triangle. One bike magnet pickup is attached to a spoke for use with the speed monitoring unit; the other is attached to the inside of the crank arm for use with the cadence monitoring unit.
Attach all pieces securely. Any sliding motion will affect accuracy.
The bike magnet pickups must pass across the monitoring units. Misalignment will affect accuracy.
BKM4 B
IKE
P
AIRING THE
WITH A SPORTS MONITORING WATCH
The BKM4 Bike Speed+Cadence Monitor must “pair” with an ANT-enabled sports monitoring watch in order to display performance data to the user. To pair your monitor:
Bring the BKM4 Bike Speed+Cadence Monitor within 10-30 inches (25-75 cm) of the sports
monitoring watch.
Ensure that you are standing at least 72 inches (183 cm) away from any other ANT-enabled bike
speed or cadence monitor. You can be in proximity to other ANT-enabled devices.
After the BKM4 Bike Speed+Cadence Monitor pairs with the sports monitoring watch, the bike icon
appears on the watch’s LCD display.
Preliminary document not for redistribution. Product features and specifications may vary. Copyright ©2005 Dynastream Innovations Inc. 6/6/2006
1
BKM4 B
IKE SPEED+CADENCE MONITOR
S
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
PECIFICATIONS
Size (max dimensions): 31 x 29 x 14 mm Weight: 14 g Power: Single user-replaceable CR-2032 battery Battery life: 5 years assuming use of 1 hr/day at 20°C Storage temp: -20°C to +70°C Operating temp: -10°C to +50°C User-interface: Auto on/off RF frequency/protocol: 2.4 GHz / Dynastream ANT transmit protocol Communication range: > 3 m (receiver dependent) Regulatory compliance: FCC, IC, and CE ready
FCC Compliance
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the product warranty and the user’s authority to operate this equipment under Part 15 regulations.
Preliminary document not for redistribution. Product features and specifications may vary. Copyright ©2005 Dynastream Innovations Inc. 6/6/2006
2
Loading...
+ 1 hidden pages