Gamo Green Laser User Manual

62120STSLLGCP - 62120STSLLCP

PRECISION LASER SIGHT AND WHITE

BLINDING LED BEAM WITH 140 LM.

INSTRUCTION MANUAL

TABLE OF CONTENTS

1. MOUNTING THE LASER AND LED LIGHT ONTO A 30MM/1 SCOPE TUBE

3. REPLACING THE LED LIGHT BATTERIES

4. REPLACING THE LASER SIGHT BATTERIES

5. ZEROING THE LASER SIGHT

6. ADJUSTING THE LASER WINDAGE AND ELEVATION

7. REPLACING THE LASER OR LED LIGHT SWITCHES

8. MAINTAINING YOUR LASER SIGHT AND LED LIGHT

Allen wrench

LED Light

Laser Sight

4

Push button
ON/OFF switches

3

Momentary

Rifle scope
not included

ON/OFF switches

2

30mm/1” mount

1

2

COMPONENTS OF THE KIT

1 - 30mm/1 Scope Tube Mount

1 LED Light
1 Laser Sight
1 Push button and 1 momentary ON/OFF LED light switch

1 Push button and 1 momentary ON/OFF laser sight switch
3 CR123A 3V. batteries, 2 for LED Light and 1 for laser sight
2 L hex wrenches

1. MOUNTING THE LASER AND LIGHT TO A 30MM/1 SCOPE TUBE

1. Attach lower half of 30mm/1” mounts to rifle scope tube.

2. Attach upper half of mounts. DO NOT TIGHTEN SCREWS YET.

3. Place laser sight and LED Light onto “W” shaped lower part of mount.

4. Place upper half of mount onto laser sight and LED Light, DO NOT TIGHTEN

SCREWS YET. Before tightening the screws in the upper half of the rings, adjust
the laser sight and LED Light back or forward for the best position to allow
removal of the push button switches or installation of the momentary ON/OFF
switches.

Align (rotate) the vertical and horizontal axes of the laser sight for the proper
alignment of the windage and elevation of the laser dot.
Tighten the screws in the upper and lower half of the mount. You can tighten all
the mount screws using a non permanent thread lock.

2. REPLACING THE LED LIGHT BATTERIES

WARNING: BE CERTAIN THAT YOUR GUN IS UNLOADED AND POINTING IN
A SAFE DIRECTION

!

Remove the push button assembly (located at the back end of the LED Light) by
turning the cap counter clockwise. Insert 2 of the CR1234A inside with the positive
end facing out. Replace the push button assembly or the momentary pressure
switch securely by turning it clockwise until tight. The LED Light is now ready for use.

3